Search NASA⌕ Search

Engineering topics

Wang, P

Publications and source records attributed to Wang, P.

25 records · Page 2

Broadband mag-noise of patterned permalloy thin films.

A Y-factor noise figure (NF) measurement method is developed to characterize high-frequency mag-noise of a 550 nm wide Permalloy strip array under different dc bias currents. The noise voltage density is obtained. The proposed lumped element transmission line model describes noise properties of the patterned Py array well. Measurement data show that rapid ferromagnetic resonance frequencies (FMR) shift induced by dc bias current is related to the excess magnetization fluctuation thermally created by the combined dc current Joule heating effects and orthogonal Oersted fields.

24 POWER TRANSMISSION AND DISTRIBUTION↗

Solution chemistry of Mo(III) and Mo(IV): Thermodynamic foundation for modeling localized corrosion.

To investigate the behavior of molybdenum dissolution products in systems that approximate localized corrosion environments, solubility of Mo(III) in equilibrium with solid MoO{sub 2} has been determined at 80 C as a function of solution acidity, chloride concentration and partial pressure of hydrogen. The measurements indicate a strong increase in solubility with acidity and chloride concentration and a weak effect of hydrogen partial pressure. The obtained results have been combined with literature data for systems containing Mo(III), Mo(IV), and Mo(VI) in solutions to develop a comprehensive thermodynamic model of aqueous molybdenum chemistry. The model is based on a previously developed framework for simulating the properties of electrolyte systems ranging from infinite dilution to solid saturation or fused salt limit. To reproduce the measurements, the model assumes the presence of a chloride complex of Mo(III) (i.e., MoCl{sup 2+}) and hydrolyzed species (MoOH{sup 2+}, Mo(OH){sup 2+}, and Mo(OH){sub 3}{sup 0}) in addition to the Mo{sup 3+} ion. The model generally reproduces the experimental data within experimental scattering and provides a tool for predicting the phase behavior and speciation in complex, concentrated aqueous solutions. Thus, it provides a foundation for simulating the behavior of molybdenum species in localized corrosion environments.

08 HYDROGEN↗

Evidence for a New Resonance and Search for the Y(4140) in the {gamma}{gamma}->{phi}J/{psi} Process

The process {gamma}{gamma}->{phi}J/{psi} is measured using a data sample of 825 fb{sup -1} collected with the Belle detector. A narrow peak of 8.8{sub -3.2}{sup +4.2} events, with a significance of 3.2 standard deviations including systematic uncertainty, is observed. The mass and natural width of the structure [named X(4350)] are measured to be [4350.6{sub -5.1}{sup +4.6}(stat)+-0.7(syst)] MeV/c{sup 2} and [13{sub -9}{sup +18}(stat)+-4(syst)] MeV, respectively. The product of its two-photon decay width and branching fraction to {phi}J/{psi} is [6.7{sub -2.4}{sup +3.2}(stat)+-1.1(syst)] eV for J{sup P}=0{sup +}, or [1.5{sub -0.6}{sup +0.7}(stat)+-0.3(syst)] eV for J{sup P}=2{sup +}. No signal for the Y(4140)->{phi}J/{psi} structure reported by the CDF Collaboration in B->K{sup +}{phi}J/{psi} decays is observed, and limits of {Gamma}{sub {gamma}}{sub {gamma}}(Y(4140))B(Y(4140)->{phi}J/{psi})<41 eV for J{sup P}=0{sup +} or <6.0 eV for J{sup P}=2{sup +} are determined at the 90% C.L. This disfavors the scenario in which the Y(4140) is a D{sub s}*{sup +}D{sub s}{sup *-} molecule.

72 PHYSICS OF ELEMENTARY PARTICLES AND FIELDS↗

EFFECT OF ENDOSPERM HARDNESS ON AN ETHANOL PROCESS USING A GRANULAR STARCH HYDROLYZING ENZYME

Granular starch hydrolyzing enzymes (GSHE) can hydrolyze starch at low temperature (32°C). The dry grind process using GSHE (GSH process) has fewer unit operations and no changes in process conditions (pH 4.0 and 32°C) compared to the conventional process because it dispenses with the cooking and liquefaction step. In this study, the effects of endosperm hardness, protease, urea, and GSHE levels on GSH process were evaluated. Ground corn, soft endosperm, and hard endosperm were processed using two GSHE levels (0.1 and 0.4 mL per 100 g ground material) and four treatments of protease and urea addition. Soft and hard endosperm materials were obtained by grinding and sifting flaking grits from a dry milling pilot plant; classifications were confirmed using scanning electron microscopy. During 72 h of simultaneous granular starch hydrolysis and fermentation (GSHF), ethanol and glucose profiles were determined using HPLC. Soft endosperm resulted in higher final ethanol concentrations compared to ground corn or hard endosperm. Addition of urea increased final ethanol concentrations for soft and hard endosperm. Protease addition increased ethanol concentrations and fermentation rates for soft endosperm, hard endosperm, and ground corn. The effect of protease addition on ethanol concentrations and fermentation rates was most predominant for soft endosperm, less for hard endosperm, and least for ground corn. Samples (soft endosperm, hard endosperm, or corn) with protease resulted in higher (1.0% to 10.5% v/v) ethanol concentration compared to samples with urea. The GSH process with protease requires little or no urea addition. For fermentation of soft endosperm, GSHE dose can be reduced. Due to nutrients (lipids, minerals, and soluble proteins) present in corn that enhance yeast growth, ground corn fermented faster at the beginning than hard and soft endosperm.

09 BIOMASS FUELS↗

Diamond Detectors for Compton Polarimetry

Parity-violating electron scattering experiments aim to test the standard model of particle physics through precise low-energy determinations of the weak mixing angle. These experiments require determination of the polarization of the incident electron beam to the 1% level or better. An example of this type of experiment is the Q-weak experiment, which will be conducted in Hall C at Jefferson Lab in 2010 and beyond. We are constructing a Compton polarimeter in Hall C to provide continuous monitoring of the polarization with the goal of 1% absolute polarization determination. In our Compton polarimeter, circularly polarized laser light will impinge upon the electron beam. Electrons scattered by the Compton process will be momentum-analyzed in a dipole magnet downstream of the interaction point. A diamond strip tracker will be placed further downstream of the dipole to sense the Compton-scattered electrons and determine their momenta. The design of the polarimeter, focusing on electron detection, and our progress in prototyping and constructing the diamond strip tracker, are discussed.

46 INSTRUMENTATION RELATED TO NUCLEAR SCIENCE AND ↗

Direct current effects on high-frequency properties of patterned permalloy thin films.

We have investigated experimentally direct current (dc) effects on high-frequency properties of two different permalloy (Py) submicrometer patterns of 0.24 mum and 0.55 mum width, 10 mum length, and 100 nm thickness. The natural ferromagnetic resonance (FMR) frequencies for the two samples are about 8.5 and 11.5 GHz. A 50 mA dc produces a FMR frequency reduction of about 1 GHz in both samples. We extracted susceptibility spectra for the samples from the measurement data. We studied inductance variations of Py embedded transmission lines for different dc levels. With 50 mA dc, the operational frequencies of the inductances decreased by 9% and 12.5%. We also tested effects of magnetic fields generated by external magnets on the submicrometer patterns for comparison. To obtain the same magnetization rotation angle, the external magnetic field needs to be about five times larger than the Ampere field created by the direct current. This behavior is unique and may be associated with the increased thermal energy from the Joule heating effects.

24 POWER TRANSMISSION AND DISTRIBUTION↗

Experimental Investigation of Iron Plasma Opacity Models

Recent experiments extended iron opacity model tests to temperatures above 150 eV for the first time. The experiments use the Z Facility to volumetrically heat a CH-tamped Fe/Mg plasma using x-rays. The frequency dependent sample transmission is measured by viewing a backlight through the sample. The plasma conditions are inferred from the Mg K-shell absorption. The strategy for this research is to examine the underlying physics within Fe opacity models by comparisons with the measured transmission. Physics topics of interest include charge state distribution, energy level structure, and line broadening. In this talk we discuss methods to exploit the data and advance understanding for these topics. In addition, we review new experiments under way to further improve the data and to achieve higher energy density conditions.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗