Engineering topics
Publications and source records attributed to Wilson, R. M..
Soft X-ray proportional-counter data for nine X-ray flares of class C1 to M1 occurring during the Skylab mission, have been analyzed to yield temperature, volume emission measure, electron density and thermal energy content. Profiles of these quantities are presented, using 1-min averages of 2.5-s resolution data. The event profiles are discussed and comparisons with previous studies made.
Annotated abstracts are presented for 221 papers containing results obtained during the 1976 period. Citations are included for 21 additional reports not reviewed.
Results of analysis of Skylab X-ray proportional counter data (10-s averages) and X-ray telescope filtergrams for the August 9, 1973 (SN/M2) subflare from McMath 12474 (NOAA AR 185) are presented. The event flux profiles and profiles of temperature, volume emission-measure, and a quantity equivalent to thermal energy content are shown. Using the proportional counter data, a peak temperature in excess of 20,000,000 K at 1552:05 UT, a peak volume emission measure of 7 x 10 to the 48th per cu cm at 1553:25 UT, and a peak value of thermal energy content of 2 x 10 to the 16th evgs/cm to the 3/2 power at 1552:45 UT were derived. Based on the analysis of spatially-resolved X-ray images during the period near flare-peak through flare-decay, the flare is observed to be both intense and compact and to consist of at least two identifiable loops whose volumes remained essentially unchanged throughout the event.
A two-dimensional planar MHD model of solar atmospheric transient events is used to simulate the flare-associated events of August 21, 1973. This event, observed in H-alpha, He II 304 A, soft X-ray, and coronal white light, provided sufficient information (especially in the latter diagnostic) for an assessment to be made of the model's ability to simulate major features of an actual solar event. It was found that a thermodynamic input pulse based on data provided by the NASA Marshall Space Flight Center-Aerospace Corporation X-ray telescope (S-056) on Skylab was sufficient to produce the global geometry, shock and contact-surface velocities, excess mass contours, and energy budget which were, for the most part, observed by the High Altitude Observatory white-light coronagraph (S-052) on Skylab in the form of a forerunner and coronal transient.
A state of the art fluid continuum technique to describe the MHD transient respose of the corona below 10 solar radii during two well observed events (flares on 21 August 1973 and 5 September 1973) is reviewed. It is concluded that the computer simulation should be subjected to in situ verification of as many of its initial assumptions as possible. Its ability to provide a rational basis for physical understanding of mass ejections suggests its use as one of the tools used in the planning and analysis of such encounter missions.
Solar active regions observed during the period of Skylab observations (May 1973-February 1974) were examined for properties that varied systematically with location on the sun, particularly with respect to the location of coronal holes. Approximately 90 percent of the optical and X-ray flare activity occurred in one solar hemisphere (136-315 heliographic degrees longitude). Active regions within 20 heliographic degrees of coronal holes were below average in lifetimes, flare production, and magnetic complexity. Histograms of solar flares as a function of solar longitude were aligned with H alpha synoptic charts on which active region serial numbers and coronal hole boundaries were added.
Observations obtained by the Skylab/Apollo telescope S-056 X-ray experiment were used to study the time-varying oscillations in the solar soft X-ray flux during a flare. The observations consisted of count rates measured every 2.5 s by sealed, gas-filled counters operating over the 2.5-7.25-A and 6.1-20.0-A wavelength ranges. The power spectra for two other intervals were computed to determine whether the observed oscillations were flare-associated or instrumental in origin. The data indicate that the oscillations in the flare-associated X-ray flux are caused by waves which are generated during the flare and which periodically increase the electron density. No oscillations were observed during quiet periods.
Observations and analyses of the 1B/M3 flare of 15 June, 1973 in active region NOAA 131 (McMath 12379) are presented. The X-ray observations, consisting of broadband photographs and proportional counter data from the Skylab/ATM NASA-MSFC/Aerospace S-056 experiment, are used to infer temperatures, emission measures, and densities for the flaring plasma. The peak temperature from the spatially resolved photographs is 25,000,000 K, while the temperature from the full-disk proportional counter data is approximately 15,000,000 K. The density is 3 times 10 to the 10th/cu cm. The X-ray flare emission appears to come primarily from two low-lying curvilinear features lying perpendicular to and centered on the line where the photospheric longitudinal magnetic field is zero. Similarities in the preflare and postflare X-ray emission patterns indicate that no large-scale relaxation of the coronal magnetic configuration was observed. Also discussed are H-alpha and magnetic field observations of the flare and the active region. Finally, results of numerical calculations, including thermal conduction, radiative loss, and chromospheric evaporation, are in qualitative agreement with the decay phase observations.
Explore the source record for details and available documents.
The chromospheric and coronal morphology of the flare of June 15, 1973, (1B/M3) in NOAA active region 131 (McMath 12379) is discussed, and results of quantitative analysis of Skylab soft X-ray observations of the event are presented. H-alpha and white-light observations reveal evidence of emerging flux near the site of the H-alpha flare onset. Preflare and early flare filament activity and its spatial and temporal correlation with the flare are discussed. Spatially resolved soft X-rays are compared with H-alpha and magnetic-field measurements. Full-disk high-temporal-resolution soft X-ray flux measurements and time profiles of the resultant temperature and density calculations are also presented which yield a peak temperature of about 14.2 million K and a peak electron density of approximately 3.5 deg 10 to the -10th power per cu cm and show a preflash-phase temperature rise to about 9 million K. The peak values should be compared with the respective values of approximately 25 million K and 4.5 by 10 to the -10th power per cu cm deduced from the spatially resolved data.
A previous treatment of prominence-induced coronal responses is extended to X-ray and H-alpha observations of an eruptive prominence and a surge by using a time-dependent two-dimensional single-fluid MHD computer code that neglects dissipation and radiation. The two events and their observation are described, and some physical parameters of the coronal plasma are derived. The observed coronal responses to ascending prominences are analyzed with the aid of the cited computer code. The results obtained indicate that: (1) the coronal response to an eruptive prominence may be simulated with a density-dominated pressure pulse of long duration; (2) the response to a surge may be simulated with a temperature pulse of short duration; and (3) the investigated eruptive-prominence disturbance injected a mass of approximately 10 to the 16th power g into the corona and was associated with a coronal transient having a calculated velocity of 275 km/s at a distance of 1.5 solar radii.
The paper describes an image data processing system (IDAPS), its hardware/software configuration, and interactive and batch modes of operation for the analysis of the Skylab/Apollo Telescope Mount S056 X-Ray Telescope experiment data. Interactive IDAPS is primarily designed to provide on-line interactive user control of image processing operations for image familiarization, sequence and parameter optimization, and selective feature extraction and analysis. Batch IDAPS follows the normal conventions of card control and data input and output, and is best suited where the desired parameters and sequence of operations are known and when long image-processing times are required. Particular attention is given to the way in which this system has been used in solar astronomy and other investigations. Some recent results obtained by means of IDAPS are presented.
The findings, based on a comparison of simultaneous observations of a number of flares obtained with the X-REA and SOLRAD 9 instruments, which reveal the degree of deterioration of the counters with time are presented.
An attempt to observe the discrete X-ray source Sco X-1 on 20 September 1973 between 0856 and 0920 UT is reported. Data obtained with the ATM/S-056 X-ray event analyzer, in particular the flux observed with the 1.71 to 4.96 KeV counter, is analyzed. No photographic image of the source was obtained because Sco X-1 was outside the field of view of the X-ray telescope.
An event compilation is presented which correlates ATM/S-056 X-ray event analyzer solar observations with solar flare activity. Approximately 1,070 h of pulse height analyzed X-ray proportional counter data were obtained with the X-ray event analyzer during Skylab. During its operation, 449 flares (including 343 flare peaks) were observed. Seventy events of peak X-ray emission or = Cl were simultaneously observed by ground based telescopes, SOLRAD 9 and/or Vela, and the X-ray event analyzer. These events were observed from preflare through flare rise to peak and through flare decline.
The 15 June 1973 1B/M3 flare was analyzed as one of the best observed flares during the skylab mission.
The Skylab ATM/S-056 X-Ray Event Analyzer, part of an X-ray telescope experiment, is described. The techniques employed in the analysis of its data to determine electron temperatures and emission measures are reviewed. The analysis of a sample event - the 15 June 1973 1B/M3 flare - is performed. Comparison of the X-Ray Event Analyzer data with that of the SolRad 9 observations indicates that the X-Ray Event Analyzer accurately monitored the sun's 2.5 to 7.25 A X-ray emission and to a lesser extent the 6.1 to 20 A emission. A mean average peak temperature of 15 million K at 1,412 UT and a mean average peak electron density (assuming a flare volume of 10 to the 13 power cu km) of 27 million/cu mm at 1,416 to 1,417 UT are deduced for the event. The X-Ray Event Analyzer data, having a 2.5 s time resolution, should be invaluable in comparisons with other high-time resolution data (e.g., radio bursts).
An overview of the last 10 years of coronal hole research, in particular since 1970, is presented. The findings of the early investigations and the more recent results obtained with Skylab/Apollo Telescope Mount instrumentation are discussed.