Engineering topics
Yoo, H.
Publications and source records attributed to Yoo, H..
Correlation of solar cell electrical properties with material characteristics of silicon cast by the ubiquitous crystallization process
Solar cells were fabricated using a conservative 'baseline' process on 1-3 Omega-cm p-type silicon from ingots cast by the ubiquitous crystallization process. Conversion efficiencies of the cells were measured, as well as spectral response and minority carrier diffusion length. Adjacent slices from the same ingot were studied for their grain size, dislocation distribution, and impurity distribution. Cell performance was related to the observed structural features, as well as to the chemical structure of the ingot.
Diagnostic study of BSF silicon solar cells
Solar cells equipped with back surface fields (BSF) were fabricated by means of an aluminum alloy, boron diffusion, and boron ion implantation. The importance of initial thickness, resistivity, orientation, and the crystal growth method were examined. Aluminum in paste form was screen printed on the cell, followed by alloy formation at 800 C for a minute. Application of the BSFs resulted in open circuit voltage improvements dependent on the substrate resistivity, ranging from 10 mV at 0.3 ohm-cm to 50 mV at 15 ohm-cm. The gains in performance were attributed to a longer penetration depth, a heightened concentration profile at the interface, and higher concentrations in the p+ layer.
Evaluation and optimization of silicon sheet solar cells
This paper describes the results and procedures to evaluate and improve the efficiency of solar cells made from various unconventional silicon sheets. The performance parameters included photovoltaic characteristics, spectral response, dark I-V characteristics, and diffusion length. The evaluation techniques used provided accurate and reliable information on sheet performance, and self-consistent results were obtained from the various measurement techniques used. Minority carrier diffusion length (L) was shown to be the ultimate limiting factor for the sheet cell performance (efficiency) and other back-up measurements confirmed this L-dependence. Limited efforts were made to identify defects which influence cell performance, and to use some improved process methods to increase cell efficiency.
Opto-electronic properties of cells made from various silicon forms
Opto-electronic properties of the various silicon forms were obtained from the solar cell performance. Performance parameters included the photovoltaic characteristics, minority carrier diffusion length, spectral response and small light spot scanning. Self consistent results were obtained from the various measurement techniques, which can provide useful information on sheet quality, as a potential for low cost terrestrial applications, and areas where the sheet formation methods can be improved.