Zerkle, Michael | Search NASA

DOE OSTI2023

Integral Experiment Request 523 CED – 1 Report

This report documents the preliminary design phase of the Critical Experiment Design (CED-1) conducted as part of integral experiment request (IER) 523. The purpose of IER-523 is to determine critical configurations of 35 weight percent (wt%) enriched uranium dioxideberyllium oxide (UO 2 -BeO) material with Seven Percent Critical Experiment (7uPCX) fuels at Sandia National Laboratories (Sandia). Preliminary experiment design concepts, neutronic analysis results, and proposed paths for continuing the CED process are presented. This report builds on the feasibility and justification of experimental need report (CED-0) completed in December 2021.

73 NUCLEAR PHYSICS AND RADIATION PHYSICS↗

DOE OSTI2023

TEX-HEU Baseline Assemblies: Highly Enriched Uranium Plates with Polyethylene Moderator and Polyethylene Reflector (IER-297 CED-4b Report)

This experiment provides the baseline experimental configurations for TEX-HEU. The purpose of the TEX-HEU design is to provide multiple configurations that span the entire neutron energy spectrum and can be easily modified to incorporate diluent materials. Future experiments utilizing the TEX-HEU design are planned to incorporate hafnium, lithium, and chlorine as diluent materials. Five experimental configurations were judged to be acceptable critical benchmark experiments.

22 GENERAL STUDIES OF NUCLEAR REACTORS↗

DOE OSTI2023

Thermal Cross Section Measurements At The RPI LINAC

Recently, a cold moderator was designed and developed for use at the Rensselaer Polytechnic Institute Linear Accelerator (RPI LINAC). This cold moderator proved to easily and safely couple to an existing neutron producing target, while enhancing neutron flux below 0.02 eV by up to a factor of 8 by cooling polyethylene down to 29 K. This cold moderator capability allowed for significantly improved counting statistics below 0.02 eV not previously possible due to a poor signal to background ratio. Additionally, testing was performed to characterize the energy resolution of the new cold moderator system and found the system easily capable of resolving resonances in Ta-181 at 4 and 10 eV, while also clearly resolving the Bragg edges found in Be metal below 0.01 eV. Furthermore, following the design and development of a cold polyethylene moderator, a series of thermal total cross section measurements were performed for polyethylene, polystyrene, Plexiglas and yttrium hydride in the thermal region. These measurements serve to help validate thermal scattering law (TSL) evaluations in the 0.0005 – 1 eV energy range. For polyethylene and polystyrene, two sets of experiments were performed – one with the Enhanced Thermal Target (ETT) and another with the ETT plus the new cold moderator capability (ETTC). The yttrium hydride and Plexiglas measurements were only performed with the ETTC. The measurements for polyethylene help to validate the data processing methodology when using the ETTC, while extending the measured range of polyethylene down to 0.0005 eV. Two different Plexiglas, Plexiglas G and Plexiglas G-UVT, and two different concentrations of yttrium hydride, H/Y = 1.85 and 1.68, were measured. Overall, all materials had generally good agreement with their ENDF/B-VIII.0 TSL evaluations, though some discrepancies were noticed. In the case of the yttrium hydride, the high energy oscillations in the hydrogen cross section and the low energy Bragg edges in the yttrium cross section were clearly seen. These measurements represent the first total cross section measurements that encompass the entire thermal region from 0.0005 – 1 eV for polystyrene and yttrium hydride.

46 INSTRUMENTATION RELATED TO NUCLEAR SCIENCE AND ↗