Search NASA⌕ Search

DOE OSTI · 1002173

Uranium(VI) Diffusion in Low-Permeability Subsurface Materials

Abstract

Uranium(VI) diffusion was investigated in a fine-grained saprolite sediment that was collected from U.S. Department of Energy (DOE) Oak Ridge site, TN, where uranium contamination in groundwater is a major environmental concern. U(VI) diffusion was studied in a diffusion cell with one cell end in contact with a large, air-equilibrated electrolyte reservoir. The pH, carbonate and U(VI) concentrations in the reservoir solution were varied to investigate the effect of solution chemical composition and uranyl speciation on U(VI) diffusion. The rates of U(VI) diffusion were evaluated by monitoring the U(VI) concentration in the reservoir solution as a function of time; and by measuring the total concentration of U(VI) extracted from the sediment as a function of time and distance in the diffusion cells. The estimated apparent rate of U(VI) diffusion varied significantly with pH with the slowest rate observed at pH 7 as a result of strong adsorptive retardation. The estimated retardation factor was generally consistent with a surface complexation model. Numerical simulations indicated that a species-based diffusion model that incorporated both aqueous and surface complexation reactions was required to describe U(VI) diffusion in the low permeability material under variable geochemical conditions. Our results implied that low permeability materials will play an important role in storing U(VI) and attenuating U(VI) plume migration at circumneutral pH conditions, and will serve as a long-term source for releasing U(VI) back to the nearby aquifer during and after aquifer decontamination.

Explore related subjects

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

Liu, Chongxuan, Zhong, Lirong, Zachara, John M. 2010-01-01. Uranium(VI) Diffusion in Low-Permeability Subsurface Materials. https://doi.org/10.1524/ract.2010.1773

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related reports

Dynamic modification of pore opening of SAPO-34 by adsorbed surface methoxy species during induction of catalytic methanol-to-olefins reactions

Here, we report that the pore opening of SAPO-34 can be significantly modified by an adsorbed surface methoxy species during induction of the catalytic methanol-to-olefins process, which offers molecular sieving properties due to physical obstacle of the methoxy group and its adsorption modification to other hydrocarbons. X-ray powder diffraction and Rietveld refinement clearly reveal that the adsorbed single carbon atom as the methoxy group is dynamically created from methanol dehydration on a Brønsted acid site in close proximity to the pore windows. As a result, industrial desirable smaller olefins such as ethylene and propylene can be favourably made at the expenses of higher olefins. The structures and fundamental understanding in alteration in the olefins selectivity during induction may allow rational optimisation in catalytic performance under the complex fluidisation conditions.

Environmental Molecular Sciences Laboratory↗

WO x supported on γ-Al 2 O 3 with different morphologies as model catalysts for alkanol dehydration

The distinctive morphological and surface characteristics of platelet-like γ-Al2O3 were compared to a regular, commercial γ-Al2O3. γ-Al2O3 platelets display dominant (110) surface facets and higher densities of coordinative unsaturated penta-coordinate Al3+ (Al3+penta) sites than regular γ-Al2O3, as measured by solid-state magic-angle spinning nuclear magnetic resonance spectroscopy (MAS NMR). Such Al3+penta sites are also the preferred surface anchoring sites for tungsten oxide (WOx) species consistent with NMR analysis indicating that these sites are consumed upon WOx adsorption. The higher Al3+penta density on γ-Al2O3 platelets leads to greater WOx dispersion (or smaller WOx clusters), as demonstrated by scanning transmission electron microscopy and ultraviolet–visible spectroscopy, and WOx species at intermediate WOx surface concentration are the most active for the probe reaction of 2-butanol dehydration. WOx on γ-Al2O3 platelets approaches the highest turnover rates at higher surface densities than WOx on regular γ-Al2O3, yet with similar highest rate values for both series of catalysts. This indicates that different Al2O3 supports mainly affect the dispersion of supported WOx rather than the intrinsic reactivity of individual WOx clusters with similar size.

Environmental Molecular Sciences Laboratory↗

Characterization of coffee (Coffea arabica) husk lignin and degradation products obtained after oxygen and alkali addition

The full use of biomass in future biorefineries has stimulated studies on utilization of lignin from agricultural crops, such as coffee husk, a major residue from coffee processing. This study focuses on characterizing the lignin obtained from coffee husk and its further wet oxidation products as a function of alkali loading, temperature and residence time. The lignin fraction after diluted acid and alkali pretreatments is composed primarily of p-hydroxylphenyl units (≥ 49%), with fewer guaiacyl and syringyl units. Linkages appear to be mainly β-O-4 ether linkages. Thermal degradation of pretreated lignin occurred in two stages. Carboxylic acids were the main degradation product. Due to the condensed structure of this lignin, relatively low yields of aromatic aldehydes were achieved, except from conditions with temperatures over 210 °C, 5 min residence time and 11.7wt% NaOH. Optimization of the pretreatment and oxidation parameters are important to maximizing yield of higher-value bioproducts from lignin.

Environmental Molecular Sciences Laboratory↗