Dynamic Species Reduction for Multi-Cycle CFD Simulations (Final Technical Report)

Abstract

This project primarily sought to address some of the computational cost concerns of detailed simulations by developing improved methods of handling species transport, and chemical kinetics evaluation in a commercial 3D Computational Fluid Dynamics (CFD) environment. Secondary goals were to apply these techniques to fuels and conditions of interest to better understand the key species and reactions required to adequately capture cycle to cycle coupling. Improved modeling will lead to better understanding of these combustion modes and their dependence on fuel composition, which can then enable more clean and efficient engines, ultimately benefiting the consumer as well as the general public. Two approaches were used to address the computational cost. A “Dynamic Species Reduction” (DSR) procedure was developed to remove chemical species from the simulation during periods when chemical reactions were not expected to be important, particularly during gas exchange when temperatures are low and little fuel remains. This modelling procedure automatically detects relevant species to retain in the simulation domain based on their local concentration, removes species below a specified concentration threshold, and then adjusts the remaining species mass to conserve not only the number of H, C, and O atoms in each cell, but also the relative proportions between species and the heating value of the mixture in every cell. The second procedure was a “Product Directed Remapping” (PDR) updates the algorithm used to group individual computational cells for chemical kinetics evaluation to account for non-uniform temperature distributions and the CO to CO 2 ratio in the cells. The model techniques developed in this work successfully demonstrated computational performance improvements for a range of conditions relevant for Highly Dilute SI and HCCI engine operation. Runtime reductions of 10% were observed for small mechanisms, with further reductions of up to 36% observed for larger mechanisms. Improvements were primarily related to reducing the number of chemical species tracked during the gas exchange process using the Dynamic Species Reduction method. With smaller benefits observed from changes to the kinetics binning and evaluation strategy in the post combustion region using the PDR method. The results of this work show the potential for improved computational runtime for complicated simulations. They can and should be extended to additional conditions and new bio-derived and renewable fuels as they are developed and new kinetic mechanisms become available.