Search NASA⌕ Search

SEARCH · Search NASA

Results for “experimental testing”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 1,801 records · Page 100

Robust delta modulation.

A new Robust Delta Modulator configuration is presented. The system is optimum in the sense of minimizing the mean square error. Under certain conditions it is shown that the optimum system reduces to an enhanced Abate scheme. The optimum system, obtained by Song, uses the polarity of the past two samples and the signal estimates, to obtain the appropriate step size. Since the signal statistics are estimated by the system they are not needed a priori. The system has been constructed and tested. Experimental pictures and voice tapes are presented.

Song, C. L.↗

Conical-reflector antennas.

The mechanical advantages of a singly curved conical reflector are demonstrated by the experimental test of a furlable 1.83 m conical-Gregorian antenna at 16.33 GHz. The measured gain of 47.5 dB corresponds to a net efficiency of over 57%. A ray-optics analysis of conical-reflector antennas is presented, and data useful in the design of conical antennas are given. The conical-Gregorian antenna, in which a subreflector is used in conjunction with a conventional horn feed, is considered in detail. A physical-optics analysis of the conical-Gregorian antenna is used to investigate diffraction and other effects, and to analytically confirm the high performance of the antenna.

Ludwig, A. C.↗

Silicon solar cell interconnectors for low temperature applications.

Discussion of the design and techniques of solar cell interconnections meeting the requirements of mission life expectancies of 5 to 10 years in the face of the vibration stresses of launch and the stresses induced (especially between dissimilar materials with different thermal coefficients of expansion) by thermal cycling throughout the mission. Generalized stress equations are developed that give the minimum stress relief loop dimensions for a 'no fatigue' interconnector. Also, the thermal expansion stresses induced at the metal-to-silicon interface were investigated and generalized equations developed for determining the stresses in each of the members. These relationships, as verified by experimental tests, can be used to determine the maximum allowable interconnector thickness for failure prevention in thermal cycling environments.

Ralph, E. L.↗

Auto-ignition of hydrocarbons behind reflected shock waves.

The paper reports on the study of auto-ignition of hydrocarbon-oxygen mixtures behind reflected shock waves. Because of their bearing on the problem of knock in internal combustion engines, n-heptane and iso-octane were chosen as the combustible species. Their stoichiometric mixtures with oxygen had to be diluted with 70% argon to reduce the influence of the boundary layer. Photographic records demonstrated the existence of two different modes of ignition, as has been previously established for the hydrogen-oxygen system. The pressure-temperature limits between these regions of mild and strong ignition were determined. From the same experimental tests, induction time data were obtained over the pressure range of 1-4 atm and the temperature interval of 1200-1700 K.

Vermeer, D. J.↗

Detection of soil microorganism in situ by combined gas chromatography mass spectrometry

Experimental tests were made to determine whether analysis of volatile metabolic products, formed in situ, is a viable procedure for an extraterrestrial life detection system. Laboratory experiments, carried out under anaerobic conditions with addition of carbon source, extended to include a variety of soils and additional substrates. In situ experiments were conducted without amendment using a vacuum sampling system.

Alexander, M.↗

Indirect Blood Pressure Measuring Device

Design and performance of a blood pressure recording device for pediatric use are reported. A strain gage transducer with a copper-beryllium strip as force sensing element is used to monitor skin movements and to convert them into electrical signals proportional to those displacements. Experimental tests with this device in recording of force developed above the left femoral artery of a dog accurately produced a blood pressure curve.

Hum, L.↗

A technique for measuring hypersonic flow velocity profiles

A technique for measuring hypersonic flow velocity profiles is described. This technique utilizes an arc-discharge-electron-beam system to produce a luminous disturbance in the flow. The time of flight of this disturbance was measured. Experimental tests were conducted in the Langley pilot model expansion tube. The measured velocities were of the order of 6000 m/sec over a free-stream density range from 0.000196 to 0.00186 kg/cu m. The fractional error in the velocity measurements was less than 5 percent. Long arc discharge columns (0.356 m) were generated under hypersonic flow conditions in the expansion-tube modified to operate as an expansion tunnel.

Gartrell, L. R.↗

Dynamic response of Mach 2.5 axisymmetric inlet with 40 percent supersonic internal area contraction

Results of experimental tests conducted on a supersonic, mixed compression, axisymmetric inlet are presented. The inlet is designed for operation at Mach 2.5 with a turbofan engine (TF-30). The inlet was terminated with either a choked-orifice plate or a long pipe with variable area choked exit plug. Frequency responses were obtained for selected static pressures in the diffuser. These pressures were selected as potential control signals for terminal shock control. Frequency responses were obtained for the Mach 2 and 2.5 conditions for different terminations. Responses also were obtained with and without cowl bleed. Internal disturbances were produced by sinusoidally varying the inlet overboard bypass doors at frequencies out to 100 hertz.

Baumbick, R. J.↗

Comparison of temperature data from an engine investigation for film-cooled and non-film-cooled, panwise-finned vanes incorporating impingement cooling

The experimental temperature characteristics of two spanwise-finned, impingement-cooled vanes, one with film cooling and one without film cooling, were investigated in a modified J-75 research turbojet engine. Values of maximum temperature, average temperature, and maximum chordwise temperature difference were compared for the two vanes at the midspan. An analytical redesign of the two vane configurations indicated that the maximum and average temperatures and the maximum chordwise temperature difference could be significantly lowered. The experimental tests indicated that suction-surface film cooling may cause increased heat transfer near the trailing edge of the vane.

Gauntner, D. J.↗

Reflectance of vegetation, soil, and water

The author has identified the following significant results. A ratio of MSS channels 5 and 7 (5/7) and 5 to 6 (5/6) signals resulted in a correct recognition of 86.9% of the members of representative crop and soil conditions, compared with recognitions of 60.0, 64.1, 74.1, and 81.4% for channels 4, 5, 6, and 7 taken individually. Based on this result a satellite channel ratio procedure has been developed that enhances line printer gray maps for more efficient experimental test site location in the CCT data. Because independent estimates are not available to judge acreage estmates derived from ERTS-1 data against, except for a few crops, an interpenetrating sample constituting 3.5% of the county is ground truthed periodically. The crop of land uses and their acreages, respectively, as estimated from the interpenetrating samples, are: cotton, 129, 714; sorghum, 182,783; mixed citrus, 53,954; oranges, 16,929; grapefruit, 13,863; rangeland, 137,845; and, improved pastures, 57.169.

Wiegand, C. L.↗

Evaluation of a device for in-flight determination of size and distribution of hailstones

A recording instrument (distrometer) for surveying the hail environment aloft was calibrated with single simulated hailstones launched from the hailstone impact simulator. The hailstone manufacture and characteristics, impact simulator, experimental test program, and resulting data are described. Hailstones 1.3, 2.5, 3.8, and 5.1 cm in diameter were impacted on the distrometer at velocities ranging from 20 to 380 m/s. An evaluation of the distrometer based on data from these tests is presented.

Alfaro-Bou, E.↗

Development of propulsion for high atmospheric pressure or dense environments

The development of a propulsion system that employs a detonating propellant is described, and the need for such a system and its use in certain planetary atmospheres are demonstrated. A theoretical formulation of the relevant gas-dynamic processes was developed, and a related series of experimental tests were pursued.

Varsi, G.↗

Moisture effects on the high-temperature strength of fiber-reinforced resin composites.

Under NAS 8-27435, the Convair Aerospace Division of General Dynamics and their subcontractor, Hercules Incorporated, have conducted studies on the effects of moisture on the properties of fiber-reinforced resin composites and on the epoxy resins presently used in advanced composites. Data are presented on the resins and composites subjected to varying time/temperature/humidity or time/temperature/water-boil exposures. The effects of moisture on matrix, reinforcement, and fiber/resin interface are discussed and supported by experimental test data.

Hertz, J.↗

Joint US/Soviet docking mission.

The purpose and objectives of the joint Apollo/Soyuz experimental test flight, the technical requirements and anticipated solutions necessary to meet the objectives, the mission plan, the flight vehicles, the schedule, and the expected results of successfully completing such a project are discussed. The androgynous feature of the docking system is provided by a symmetrical distribution of all elements which are directly connected during docking, relative to the axis of reverse symmetry. Both the American and Russian systems are designed to serve as either the active or passive system for docking and undocking.

Scott, D. R.↗

Thermoelastic analysis of solar cell arrays and their material properties

Announced report discusses experimental test program in which five different solar cell array designs were evaluated by subjecting them to 60 thermal cycles from minus 190 deg to 0.0 deg. Results indicate that solder-coated cells combined with Kovar n-interconnectors and p-interconnectors are more durable under thermal loading than other configurations.

Salama, M. A.↗

Surface roughness effects on the supersonic aerodynamics of the Rockwell International 089B-139 orbiter

An experimental test program was conducted to determine the effects of vehicle surface roughness on the supersonic aerodynamic characteristics of a 0.01875 scale model of a space shuttle configuration. Surface roughness was simulated by applying a sparse coating of carborundum grit to complete model. Various grit sizes were investigated. The tests were conducted in a wind tunnel at Mach numbers from 1.60 to 4.63. The angle of attack was varied from about -2 deg to as much as 42 deg at 0 deg and + or - 3 deg of sideslip. The angle of sideslip was varied from -8 deg to 8 deg at angles of attack from 0 deg to 40 deg.

Ware, G. M.↗

Surface roughness effects on the subsonic aerodynamics of the Rockwell International 089B-139B orbiter

An experimental test program was conducted to determine the effects of vehicle surface roughness on the subsonic aerodynamic characteristics of a 0.01875 scale model of a Rockwell International Space Shuttle Configuration. Surface roughness was simulated by applying a sparce coating of carborundum grit to the complete model. Various grit sizes were investigated. Tests were conducted in the Langley Low Turbulence Pressure Tunnel at a constant nominal Mach number of 0.25 with Reynolds number varying from 2 to 12 x 10 to the 6th power per foot. Angle of attack was varied from about -2 to 28 deg at 0 deg and 6 deg angle of sideslip.

Ware, G. M.↗

Channel simulation for direct detection optical communication systems

A technique is described for simulating the random modulation imposed by atmospheric scintillation and transmitter pointing jitter on a direct detection optical communication system. The system is capable of providing signal fading statistics which obey log normal, beta, Rayleigh, Ricean or chi-squared density functions. Experimental tests of the performance of the Channel Simulator are presented.

Tycz, M.↗

Refine your search to explore more results.