Microscopy Visualization of Carrier Transport in CdSeTe/CdTe Solar Cells
Not Available
SEARCH · Search NASA
Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.
Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.
Not Available
Efficient high-power operation of light emitting diodes based on InGaN quantum wells (QWs) requires rapid interwell hole transport and low nonradiative recombination. The transport rate can be increased by replacing GaN barriers with that of InGaN. Introduction of InGaN barriers, however, increases the rate of the nonradiative recombination. In this work, we have attempted to reduce the negative impact of the nonradiative recombination by introducing thin GaN or AlGaN interlayers at the QW/barrier interfaces. The interlayers, indeed, reduce the nonradiative recombination rate and increase the internal quantum efficiency by about 10%. Here, the interlayers do not substantially slow down the interwell hole transport; for 0.5 nm Al 0.10 Ga 0.90 N interlayers the transport rate has even been found to increase. Another positive feature of the interlayers is narrowing of the QW PL linewidth, which is attributed to smoother QW interfaces and reduced fluctuations of the QW width.
When a semiconductor sample is irradiated by means of an external source, emitting photons or electrons, excess carriers are produced which distribute themselves throughout the sample. One of the parameters which determine the distribution of the carriers is the surface recombination velocity. The present investigation is concerned with the recombination lifetime tau. The predominant mechanism for recombination in wide band-gap semiconductors is described by the Shockley-Read-Hall (SRH) theory. The transport equations are derived for free carriers and the radiation field. The considered theory is applied to a semiinfinite, one-dimensional semiconductor slab irradiated by light of a given frequency. Some numerical considerations based on n-type GaAs are presented. Attention is given to a determination of the radiation transmitted through the surface of the sample.
Here, the origin of p-type conductivity and the mechanism responsible for low carrier mobility were investigated in pyrite (FeS 2 ) thin films. Temperature-dependent resistivity measurements (10-400 K) were performed on polycrystalline and nanostructured thin films prepared by three different methods: (1) spray pyrolysis, (2) hot-injection synthesized and spin-coated nanocubes, and (3) pulsed laser deposition. The films have a high hole density (10 18 -10 19 ) cm -3 and low mobility (0.1-4 cm 2 V -1 s -1 ) regardless of the method used for their preparation. The charge transport mechanism is determined to be thermally activated conduction (TAC) at near room temperature, with Mott-type variable-range hopping (VRH) of holes via localized states occurring at lower temperatures. The density functional theory (DFT) predicts that sulfur vacancy induces localized defect states within the band gap and the charge remains localized around the defect. The data indicates that the electronic properties including hopping transport in pyrite thin films can be correlated to sulfur vacancy-related defects. The results provide insights into the electronic properties of pyrite thin films and their implications for charge transport.
Abstract Cadmium telluride (CdTe) semiconductors are used in thin-film photovoltaics, detectors, and other optoelectronic applications. For all technologies, higher efficiency and sensitivity are achieved with reduced charge carrier recombination. In this study, we use state-of-the-art CdTe single crystals and electro-optical measurements to develop a detailed understanding of recombination rate dependence on excitation and temperature in CdTe. We study recombination and carrier dynamics in high-resistivity (undoped) and arsenic (As)-doped CdTe by employing absorption, the Hall effect, time-resolved photoluminescence, and pump-probe in the 80–600 K temperature range. We report extraordinarily long lifetimes (30 µs) at low temperatures in bulk undoped CdTe. Temperature dependencies of carrier density and mobility reveal ionization of the main acceptors and donors as well as dominant scattering by ionized impurities. We also distinguish different recombination defects. In particular, shallow As Te and deep V Cd −As Cd acceptors were responsible for p-type conductivity. AX donors were responsible for electron capture, while nonradiative recombination centers (V Cd −As Te , As 2 precipitates), and native defects (V Cd −Te Cd ) were found to be dominant in p-type and n-type CdTe, respectively. Bimolecular and surface recombination rate temperature dependencies were also revealed, with bimolecular coefficient T −3/2 temperature dependence and 170 meV effective surface barrier, leading to an increase in surface recombination velocity at high temperatures and excitations. The results of this study allowed us to conclude that enhanced crucible rotation growth of As-doped CdTe is advantageous to As activation, leading to longer lifetimes and larger mobilities and open-circuit voltages due to lower absorption and trapping.
Cell envelope vesicles prepared from H. halobium contain bacteriorhodopsin and upon illumination protons are ejected. Coupled to the proton motive force is the efflux of Na(+). Measurements of Na-22 flux, exterior pH change, and membrane potential, Delta(psi) (with the dye 3,3'-dipentyloxadicarbocyanine) indicate that the means of Na(+) transport is sodium/proton exchange. The kinetics of the pH changes and other evidence suggests that the antiport is electrogenic (H(+)/Na(++ greater than 1). The resulting large chemical gradient for Na(+) (outside much greater than inside), as well as the membrane potential, will drive the transport of 18 amino acids. The I9th, glutamate, is unique in that its accumulation is indifferent to Delta(psi): this amino acid is transported only when a chemical gradient for Na(+) is present. Thus, when more and more NaCl is included in the vesicles glutamate transport proceeds with longer and longer lags. After illumination the gradient of H+() collapses within 1 min, while the large Na(+) gradient and glutamate transporting activity persists for 10- 15 min, indicating that proton motive force is not necessary for transport. A chemical gradient of Na(+), arranged by suspending vesicles loaded with KCl in NaCl, drives glutamate transport in the dark without other sources of energy, with V(sub max) and K(sub m) comparable to light-induced transport. These and other lines of evidence suggest that the transport of glutamate is facilitated by symport with Na(+), in an electrically neutral fashion, so that only the chemical component of the Na(+) gradient is a driving force.
We report that zinc oxide (ZnO) nanomaterials are promising components for chemical and biological sensors and photocatalytic conversion and operate as electron collectors in photovoltaic technologies. Many of these applications involve nanostructures in contact with liquids or exposed to ambient atmosphere. Under these conditions, single-crystal ZnO surfaces are known to form narrow electron accumulation layers with few nanometer spatial penetration into the bulk. A key question is to what extent such pronounced surface potential gradients can develop in the nanophases of ZnO, where they would dominate the catalytic activity by modulating charge-carrier mobility and lifetimes. Here, we follow the temperature-dependent surface electronic structure of nanoporous ZnO with photoemission spectroscopy to reveal a sizable, spatially averaged downward band bending for the hydroxylated state and a conservative upper bound of < 6 nm for the spatial extent of the associated potential gradient. This nanoscale confinement of conduction-band electrons to the nanoparticle film surface is crucial for a microscopic understanding and further optimization of charge transport and photocatalytic function in complex ZnO nanomaterials.
Red InGaN-based light-emitting diodes (LEDs) exhibit lower internal quantum efficiencies than violet, blue, and green InGaN LEDs due to a reduction in radiative recombination rates relative to non-radiative recombination rates as the Indium composition increases. Additionally, the larger polarization and band offset barriers between high indium content InGaN quantum wells and GaN quantum barriers increase the forward voltage. In blue and green LEDs, random alloy fluctuations and V-defects play a key role in reducing the forward voltage. When V-defects are present, either naturally or intentionally introduced, they create an alternative path for carrier injection into the MQWs through the V-defect sidewalls. This injection mechanism explains the turn-on voltages of green LEDs. However, in InGaN red LEDs, these two phenomena do not reduce the forward voltage as effectively as in blue and green LEDs, and consequently, the computed forward voltage remains significantly higher than the measured one. Furthermore, currents are observed at low voltages before the turn-on voltage (V<ℏω/e=2.0 V) of red LEDs. To address this, we introduce dislocation-induced tail states in the modeling, suggesting that leakage current through these states may play a significant role both below and at turn-on voltages. The simulation also indicates that leakage carriers below turn-on accumulate, partially diffuse in the QWs, screen the polarization-induced barrier in the low injection regime, and further reduce the forward voltage. Despite these beneficial effects, a drawback of dislocation-induced tail states is the enhanced nonradiative recombination in the dislocation line region. This study provides a detailed analysis of device injection physics in InGaN QW red LEDs and outlines potential optimization strategies.
Not Available
Until recently, the electrical efficiency of green nitride light-emitting diodes (LEDs) was considerably lower than that of blue LEDs. This is particularly surprising as one would expect a reduced forward voltage with increasing emission wavelength. In this paper, we theoretically investigated the impact of the number of quantum wells on the forward voltage of III-nitride LEDs with x = 0.15 (blue) and x = 0.24 (green) In x Ga1–xN QWs. The simulated dependence of current density (J) on applied diode bias (V) shows a significant increase of 1.9 V in the forward voltage between one and five quantum well (QW) c-plane green LED structures. Artificially turning off the polarization fields in the simulation does not entirely suppress this effect. Due to the large band offsets in the green LED multiple QW stack, simulations indicate a sequential band filling of the QW sequence. Furthermore, this mechanism should not be limited to c-plane LEDs and could also be present in nonpolar or semipolar devices.
Not Available