Search NASA⌕ Search

SEARCH · Search NASA

Results for “Antenna radiation patterns”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 361 records · Page 20
All sourcesNASA NTRSDOE OSTI
NASA NTRS1981

Study of high speed complex number algorithms

A method of evaluating the radiation integral on the curved surface of a reflecting antenna is presented. A three dimensional Fourier transform approach is used to generate a two dimensional radiation cross-section along a planer cut at any angle phi through the far field pattern. Salient to the method is an algorithm for evaluating a subset of the total three dimensional discrete Fourier transform results. The subset elements are selectively evaluated to yield data along a geometric plane of constant. The algorithm is extremely efficient so that computation of the induced surface currents via the physical optics approximation dominates the computer time required to compute a radiation pattern. Application to paraboloid reflectors with off-focus feeds in presented, but the method is easily extended to offset antenna systems and reflectors of arbitrary shapes. Numerical results were computed for both gain and phase and are compared with other published work.

Heisler, R.↗
NASA NTRS1984

The study of microstrip antenna arrays and related problems

The physical layout of the array elements and the proximity of the microstrip feed network makes the input impedance and radiation pattern values dependent upon the effects of mutual coupling, feedline discontinuities and feed point location. The extent of these dependences was assessed and a number of single patch and module structures were constructed and measured at an operating frequency of approximately 4.0 GHz. The empirical results were compared with the ones which were theoretically predicted by the cavity model of thin microstrip antennas. Each element was modelled as an independent radiating patch and each microstrip feedline as an independent, quasi-TEM transmission line. The effects of the feedline discontinuities are approximated by lumped L-C circuit models.

Lo, Y. T.↗
NASA NTRS1991

Millimeter-wave integrated-horn antennas. I - Theory. II - Experiment

Full-wave analysis is employed to determine the far-field pattern and input impedance of a dipole-fed horn antenna in a ground plane, and the theoretical results are compared with mm-wave and microwave data. The theoretical work exploits the Green's function corresponding to the horn structure and the method of moments. It is determined that the horn should have 70 sections/wavelength and 50 secondary modes for optimized accuracy, and certain dipole positions can reduce the resonance to zero. The experimentally derived impedance and radiation patterns agree with the constraints developed theoretically. The 70-degree flare-angle horn with selected dipole positions and horn apertures yields good radiation patterns, cross-polarization levels, and resonant dipole impedances. The conclusions are of interest to the development of the horn antennas etched in Si/GaAs for applications to zero-visibility tracking, radio astronomy, plasma diagnostics, and remote sensing.

Eleftheriades, George V.↗
NASA NTRS1989

Nonprincipal plane scattering of flat plates and pattern control of horn antennas

Using the geometrical theory of diffraction, the traditional method of high frequency scattering analysis, the prediction of the radar cross section of a perfectly conducting, flat, rectangular plate is limited to principal planes. Part A of this report predicts the radar cross section in nonprincipal planes using the method of equivalent currents. This technique is based on an asymptotic end-point reduction of the surface radiation integrals for an infinite wedge and enables nonprincipal plane prediction. The predicted radar cross sections for both horizontal and vertical polarizations are compared to moment method results and experimental data from Arizona State University's anechoic chamber. In part B, a variational calculus approach to the pattern control of the horn antenna is outlined. The approach starts with the optimization of the aperture field distribution so that the control of the radiation pattern in a range of directions can be realized. A control functional is thus formulated. Next, a spectral analysis method is introduced to solve for the eigenfunctions from the extremal condition of the formulated functional. Solutions to the optimized aperture field distribution are then obtained.

Balanis, Constantine A.↗
NASA NTRS2014

Dielectric Covered Planar Antennas

An antenna element suitable for integrated arrays at terahertz frequencies is disclosed. The antenna element comprises an extended spherical (e.g. hemispherical) semiconductor lens, e.g. silicon, antenna fed by a leaky wave waveguide feed. The extended spherical lens comprises a substantially spherical lens adjacent a substantially planar lens extension. A couple of TE/TM leaky wave modes are excited in a resonant cavity formed between a ground plane and the substantially planar lens extension by a waveguide block coupled to the ground plane. Due to these modes, the primary feed radiates inside the lens with a directive pattern that illuminates a small sector of the lens. The antenna structure is compatible with known semiconductor fabrication technology and enables production of large format imaging arrays.

Llombart Juan, Nuria↗
NASA NTRS1979

Feasibility of inertialess conscan utilizing modified DSN feedsystems

The closed-loop conical-scan (conscan) technique has proven to be a useful method for pointing the DSN antennas more accurately than is possible by open-loop methods. As presently implemented, the antenna beam is scanned about the received signal direction by physical movement of the antenna. While straightforward, this approach has at least two disadvantages. Firstly, because of structural distortions, finite angle encoder resolution, and drive servo response, the actual antenna beam direction only approximates the commanded beam direction. Secondly, because of the large mass moved during scan, the rate of scan is severely restricted. If there are significant gain or signal level variations during a scan period, the conscan system interprets these variations as antenna pointing error. Both of these disadvantages would be alleviated in an inertialess conscan system in which the beam scanning was performed electronically. Recently, standard JPL antenna feedhorn software was upgraded to calculate, among other things, asymmetric corrugated horn radiation patterns of the type that would be needed for electronic beam scan. The required horn excitation is discussed and the results were described.

Potter, P. D.↗
NASA NTRS1986

Microstrip Antenna Generates Circularly Polarized Beam

Circular microstrip antenna excited with higher order transverse magnetic (TM) modes generates circularly polarized, conical radiation patterns. Found both theoretically and experimentally that peak direction of radiation pattern is varied within wide angular range by combination of mode selection and loading substrate with materials of different dielectric constants.

Huang, J.↗
NASA NTRS2012

Ka-and Reflectarray for Interferometric SAR Altimeter

This paper describes a large dual-beam, dual polarized Ka-Band reflectarray antenna prototype which was developed to demonstrate that key requirements of a space borne interferometric radar altimeter are achievable. The antenna consists of a 2.5 x 0.26 m aperture comprised of a rectangular grid of square patch printed circuit elements. The 2.6 m focal length offset-fed reflector is illuminated by a waveguide slot array feed focused in the nearfield. Measured results show good agreement with gain and radiation pattern predictions and demonstrates >50% aperture efficiency.

radar↗
NASA NTRS1995

Low profile antennas for MSAT applications

For MSAT applications, a number of different antennas have been designed and investigated. They include low gain omnidirectional antennas and medium gain to high gain directional antennas. The latter include both portable and vehicular antennas. While portable units are desirable to be low profile and low cost, the vehicular antennas have proved to be the most challenging antenna types for the mobile satellite application. The results of our efforts in design of such antennas are described briefly. Low profile designs are emphasized in most cases, and microstrip type radiators are therefore selected. The single radiator provides low gain omnidirectional patterns and is optimized for low cost applications. It provides low gains around 2-6 dBic and is useful mostly for the data transmission. Medium to high gain antennas are developed as arrays of omnidirectional elements. Again, different designs are optimized to meet the needs of different applications. For portable units, the array configuration can be flexible and is optimized for maximum broadside gains. For vehicular units, however the configurations are desirable to be low profile, or compact, and have means for scanning the antenna beam. For simplicity, fixed beam antennas with mechanical beam scan are selected. For these antennas, as well, different designs, having low profile or compact size, are selected and optimized to meet the MSAT gain and G/T requirements.

Shafai, L.↗
NASA NTRS1976

Power conservation for reflector antennas with truncated feed patterns

Reflector-antenna calculations using idealised truncated feed patterns can lead to incorrect values of total secondary radiated power. It is demonstrated that this discrepancy is due to the presence of higher-order spherical modes incident on the reflector. When a proper spherical-wave expansion of the incident field is used, in conjunction with the physical-optics technique, to determine the scattered field, the total power of the scattered field will equal the power radiated by the feed.

Rush, W. V. T.↗
NASA NTRS1996

Antennas For Receiving Signals Broadcast Via Satellites

Four different antennas designed for use in receiving radio AM and FM signals broadcast via Earth-orbiting satellites at carrier frequency of 2.05 GHz in right-hand circular polarization. Antennas small, lightweight, inexpensive units with low-to-medium-gain, quasi-omnidirectional radiation patterns. Designed for outdoor and indoor uses.

Wu, Te-Kao↗
NASA NTRS2002

Folded Coplanar Waveguide Slot Antenna on Silicon Substrates With a Polyimide Interface Layer

A novel mm-wave Coplanar Waveguide (CPW) folded slot antenna is characterized on low-resistivity Si substrate (1 omega-cm) and a high resistivity Si substrate with a polyimide interface layer for the first time. The antenna resonates around 30 GHz with a return loss greater than 14.6 dB. Measured radiation patterns indicate the existence of a main lobe, but the radiation pattern is affected by a strong surface wave mode, which is greater in the high resistivity Si wafer.

Bacon, Andrew↗
NASA NTRS2022

Simulated 8x8 Ku-Band Array Antenna Performance on Airplane Door

An 8x8, Ku-band antenna array composed of circular patches was simulated both on an infinite ground plane and mounted on an airplane door. The radiated far field was calculated for both cases to determine the effect of mounting the antenna on the side of the airplane. It was found that the main beam was relatively unaffected, while the sidelobes were increased by 15 to 20 dB at angles more than 30° off boresight..

array antenna↗
NASA NTRS1992

New coplanar waveguide feed network for 2 x 2 linearly tapered slot antenna subarray

A novel feed method is presently demonstrated for a 2 x 2 linearly tapered slot antenna (LTSA) on the basis of a coplanar-waveguide (CPW)-to-slotline transition and a coax-to-CPW in-phase, four-way power divider. The LTSA subarray exhibits excellent radiation patterns and return-loss characteristics at 18 GHz, and has symmetric beamwidth; its compactness renders it applicable as either a feed for a reflector antenna or as a building-block for large arrays.

Simons, Rainee N.↗
NASA NTRS1965

Primary feeds for the Goonhilly satellite-communication aerial

The 85-ft. diameter aerial at Goonhilly Downs, Cornwall uses a focal-plane paraboloidal reflector illuminated from a primary feed at the focus, Circularly polarized waves are transmitted and received. For optimum gain and uniformity of the aerial radiation patterns, circular symmetry of the primary feed radiation pattern is desirable. The primary feed has therefore been made circularly symmetric.

GROUND STATION↗
NASA NTRS1974

Radiation and scattering by thin-wire structures in the complex frequency domain

Piecewise-sinusoidal expansion functions and Galerkin's method are employed to formulate a solution for an arbitrary thin-wire configuration in a homogeneous conducting medium. The analysis is performed in the real or complex frequency domain. In antenna problems, the solution determines the current distribution, impedance, radiation efficiency, gain and far-field patterns. In scattering problems, the solution determines the absorption cross section, scattering cross section and the polarization scattering matrix. The electromagnetic theory is presented for thin wires and the forward-scattering theorem is developed for an arbitrary target in a homogeneous conducting medium.

Richmond, J. H.↗