Search NASA⌕ Search

SEARCH · Search NASA

Results for “Retain”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 505 records · Page 28
All sourcesNASA NTRSDOE OSTI
NASA NTRS1975

Investigation of an inverted meniscus heat pipe wick concept

A wicking concept is described for efficient evaporation of heat pipe working fluids under diverse conditions. It embodies the high heat transfer coefficient of the circumferential groove while retaining the circumferential fluid transport capability of a thick porous wick or screen. Experimental tests are described which substantiate the efficacy of the evaporation technique for a circumferentially-grooved heat pipe charged alternately with ammonia and R-ll (CCl3F). With ammonia, heat transfer coefficients in the range of 2 to 2.7 W/sq cm K were measured at heat flux densities up to 20 W/sq cm while, with R-ll, a heat transfer coefficient of l.0 W/sq cm K was measured with flux densities up to 5 W/sq cm. Heat transfer coefficients and flux densities were unusually high compared to literature data for other nonboiling evaporative surfaces.

Saaski, E. W.↗
NASA NTRS1975

Design and application of squeeze film dampers for turbomachinery stabilization

The steady-state transient response of the squeeze film damper bearing was investigated. Both the steady-state and transient equations for the hydrodynamic bearing forces are derived; the steady-state equations were used to determine the damper equivalent stiffness and damping coefficients. These coefficients are used to find the damper configuration which will provide the optimum support characteristics based on a stability analysis of the rotor-bearing system. The effects of end seals and cavitated fluid film are included. The transient analysis of rotor-bearing systems was conducted by coupling the damping and rotor equations and integrating forward in time. The effects of unbalance, cavitation, and retainer springs are included. Methods of determining the stability of a rotor-bearing system under the influence of aerodynamic forces and internal shaft friction are discussed.

Gunter, E. J.↗
NASA NTRS1974

On the flame spreading over a polymer surface

The characteristics of flame propagation along the interface between a solid fuel and a gaseous oxidizer are considered. It is found that difficulties in a study of this problem are related to the eigenvalue character of the relative velocity of the flame with respect to the oxidizer flow. In the proposed model of flame spreading the difficulties are overcome by retaining the ellipticity of the governing equations and by taking the surface pyrolysis into account. The solution procedure makes use of a sink-source approach and the Fourier-transform method. Flame propagation velocity data computed on the basis of the described approach are compared with experimental results.

Ohki, Y.↗
NASA NTRS1974

Inclusion of transverse shear deformation in finite element displacement formulations

A stiffness matrix is derived for a beam element with transverse shear deformation. It is shown that straightforward energy minimization yields the correct stiffness matrix in displacement formulations when transverse shear effects are considered. Since the TIM4 beam element does not represent the geometric boundary conditions for a cantilever beam the rotation of the normal must be retained as a grid point degree of freedom.

Narayanaswami, R.↗
NASA NTRS1974

Geochemical affinities of cobalt and germanium toward metal, silicate, and sulfide phases at high temperature

Hydrothermal studies indicate that Co and Ge are strongly siderophile when metallic iron is in equilibrium with olivine at 900 C and 500 bars. If the metal is replaced by troilite (FeS), Ge is strongly lithophile whereas Co tends to concentrate in the sulfide phase. If iron meteorites were formed in a core derived from the sulfide phase, they would be depleted in Ge but retain Co.

Wai, C. M.↗
NASA NTRS1974

Consideration of materials for aircraft brakes

A study has been made of the frictional behavior of several aircraft brake materials using a simple high-temperature Falex-type apparatus. Tests were run at velocities of seven ft/minute; loads to 600 pounds and temperatures to 700 C. The data for these brake materials sliding against a variety of steels and other materials indicate a large reduction in friction due to surface oxidation in the temperature range 250 to 300 C. It also was found that the retention of this oxide was a function of the temperature changes. With increasing temperature the oxide was removed, while with reducing temperature it was retained. Frictional behavior was more characteristic of the steel than the brake material.

Peterson, M. B.↗
NASA NTRS1974

Mass ejections from the sun - A view from Skylab

More than 30 instances of sudden mass ejections from the sun were observed with the white light coronagraph experiment aboard Skylab during the first 118 days of the mission. Typically, these ejections appear as large magnetic loops rooted at the sun, yet expanding outward through the solar corona at speeds of the order of 400 km/sec. The loops always appear to retain their magnetic connection to the sun. Eighteen of these ejections were associated with active and eruptive prominences and surges; only three ejections appear to have been flare initiated. Associations with ground-detected metric wavelength type 2 and 4 radio bursts occur for about 30% of these events; however, ground-detected type 2 and 4 radio bursts originating near the limb are almost invariably accompanied by coronagraph-observed ejections. Pressure or MHD waves run out ahead of the transient material ejecta; at times these waves can be detected by their effects on nearby coronal structures.

Gosling, J. T.↗
NASA NTRS1974

Transient analysis of a thermal storage unit involving a phase change material

The transient response of a single cell of a typical phase change material type thermal capacitor has been modeled using numerical conductive heat transfer techniques. The cell consists of a base plate, an insulated top, and two vertical walls (fins) forming a two-dimensional cavity filled with a phase change material. Both explicit and implicit numerical formulations are outlined. A mixed explicit-implicit scheme which treats the fin implicity while treating the phase change material explicitly is discussed. A band algorithmic scheme is used to reduce computer storage requirements for the implicit approach while retaining a relatively fine grid. All formulations are presented in dimensionless form thereby enabling application to geometrically similar problems. Typical parametric results are graphically presented for the case of melting with constant heat input to the base of the cell.

Griggs, E. I.↗
NASA NTRS1974

A neon-E-rich phase in the Orgueil carbonaceous chondrite

Attention is given to a procedure for separating a silicate fraction which contains large amounts of neon-E from the carbonaceous chondrite Orgueil. In this fraction a 20Ne/22Ne ratio of 4.56 is measured. The obtained data support the hypothesis that neon-E might be associated with interstellar dust grains of the type not fully homogenized with the solar system and which retain some of their trapped neon. Neon results in a three-isotope diagram are presented.

Eberhardt, P.↗
NASA NTRS1974

An improved version of the table look-up algorithm for pattern recognition

The table look-up approach to pattern recognition has been used for 3 years at several research centers in a variety of applications. A new version has been developed which is faster, requires significantly less core memory, and retains full precision of the input data. The new version can be used on low-cost minicomputers having 32K words (16 bits each) of core memory and fixed-point arithmetic; no special-purpose hardware is required. An initial FORTRAN version of this system can classify an ERTS computer-compatible tape into 24 classes in less than 15 minutes.

Eppler, W. G.↗
NASA NTRS1974

The instability of strong magnetic fields in stellar interiors

There has been discussion of the possibility of resolving the solar neutrino dilemma with a sufficiently strong magnetic field (500 MG) in the solar interior to relieve the gas pressure by some 10% or more. The time in which magnetic buoyancy will bring a strong field to the surface is examined and is found to be less than 100 m.y. No possibility is seen for retaining a suitably strong magnetic field in the solar interior.

Parker, E. N.↗
NASA NTRS1974

Stability properties of functional difference equations

Hale and Cruz (1970) have defined the concept of a stable difference operator, and have found that this class of operators is sometimes 'super sensitive' to perturbations. In the present paper, a subclass of general functional difference equations is derived which retain their stability under appropriate perturbations. Also, the results of Hale and Cruz are extended to include difference equations on the Banach space of p-th power integrable functions, and essentially bounded functions.

Melvin, W. R.↗
NASA NTRS1975

Propagation of sound in elliptic ducts

The paper studies the propagation of sound in an elliptic duct, which is of considerable interest in the field of jet-engine noise reduction. The cutoff frequencies of the higher-order circumferential modes in an elliptic duct are calculated for various duct eccentricities. The results indicate that, if equal inlet area is retained, even major deformations of the inlet shape will have virtually no influence on the cutoff conditions of the radiated sound.

Lowson, M. V.↗
NASA NTRS1975

Multifilamentary niobium tin superconductor tape

In the method proposed for fabricating multifilamentary Nb3Sn tape, filamentary superconducting paths are produced in standard commercial superconductor tape by chemical milling of separator slots through the Nb3Sn layer. The multifilament configuration features a matrix of ten 1.2 mm wide parallel helical superconducting paths along the length of the tape. The paths are spaced 0.4 mm apart. Tapes tested as small pancake coils demonstrated the integrity and continuity of the matrix, and showed that critical current was sustained in direct proportion to retained superconductor.

Brisbin, P. H.↗
NASA NTRS1975

Modal equations for cellular convection

We expand the fluctuating flow variables of Boussinesq convection in the planform functions of linear theory. Our proposal is to consider a drastic truncation of this expansion as a possible useful approximation scheme for studying cellular convection. With just one term included, we obtain a fairly simple set of equations which reproduces some of the qualitative properties of cellular convection and whose steady-state form has already been derived by Roberts (1966). This set of 'modal equations' is analyzed at slightly supercritical and at very high Rayleigh numbers. In the latter regime the Nusselt number varies with Rayleigh number just as in the mean-field approximation with one horizontal scale when the boundaries are rigid. However, the Nusselt number now depends also on the Prandtl number in a way that seems compatible with experiment. The chief difficulty with the approach is the absence of a deductive scheme for deciding which planforms should be retained in the truncated expansion.

Gough, D. O.↗
NASA NTRS1975

Large fracture toughness boron-epoxy composites

The high tensile strengths of strong interfacial bonding may be combined with the large fracture toughness of weak interfacial bonding in brittle fiber/brittle matrix composites by intermittently coating the filaments before layup so as to have random alternate weak and strong regions. Appropriate coating materials enable Cook-Gordon Mode I interfacial debonding to take place, which produces very long pull-out lengths with an associated large contribution to toughness. Unidirectional boron-epoxy composites have been so made which have toughnesses greater than 200 kJ/sq m while retaining rule of mixtures tensile strengths. Similar trends have been observed for crossply layups.

Atkins, A. G.↗
NASA NTRS1975

A new structural analysis/synthesis capability - ACCESS

The creation of an efficient automated capability for minimum weight design of structures is reported. The ACCESS 1 computer program combines finite element analysis techniques and mathematical programming algorithms using an innovative collection of approximation concepts. Design variable linking, constraint deletion techniques and approximate analysis methods are used to generate a sequence of small explicit mathematical programming problems which retain the essential features of the design problem. Organization of the finite element analysis is carefully matched to the design optimization task. The efficiency of the ACCESS 1 program is demonstrated by giving results for several example problems.

Schmit, L. A.↗
NASA NTRS1974

GOAL - A test engineer oriented language

The development of a test engineer oriented language has been under way at the Kennedy Space Center for several years. The result of this effort is the Ground Operations Aerospace Language, GOAL, a self-documenting, high-order language suitable for coding automatic test, checkout and launch procedures. GOAL is a highly readable, writable, retainable language that is easily learned by nonprogramming oriented engineers. It is sufficiently powerful for use at all levels of Space Shuttle ground processing, from line replaceable unit checkout to integrated launch day operations. This paper will relate the language development, and describe GOAL and its applications.

Mitchell, T. R.↗