Search NASA⌕ Search

SEARCH · Search NASA

Results for “Lift coefficient”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 1,081 records · Page 60

In-flight measurements of the GA/W/-2 aerodynamic characteristics

Flight tests of a new 13% General Aviation Airfoil - the GA(W)-2 - gloved full span onto the existing wing of a Beech Sundowner have generated chordwise pressure distributions and wake surveys. Section lift, drag and moment coefficients derived from these measurements verify wind tunnel data and theory predicting the performance of this airfoil. The effect of steps, rivets and surface coatings upon the drag of the GA(W)-2 was also evaluated.

Gregorek, G. M.↗

Vortex lattice prediction of subsonic aerodynamics of hypersonic vehicle concepts

The vortex lattice method introduced by Lamar and Gloss (1975) was applied to the prediction of subsonic aerodynamic characteristics of hypersonic body-wing configurations. The reliability of the method was assessed through comparison of the calculated and observed aerodynamic performances of two National Hypersonic Flight Research Facility craft at Mach 0.2. The investigation indicated that a vortex lattice model involving 120 or more panel elements can give good results for the lift and induced drag coefficients of the craft, as well as for the pitching moment at angles of attack below 10 to 15 deg. Automated processes for calculating the local slopes of mean-camber surfaces may also render the method suitable for use in preliminary design phases.

Pittman, J. L.↗

Iterative optimal subcritical aerodynamic design code including profile drag

A subcritical aerodynamic design computer code has been developed, which uses linearized aerodynamics along with sweep theory and airfoil data to obtain minimum total drag preliminary designs for multiple planform configurations. These optimum designs consist of incidence distributions yielding minimum total drag at design values of Mach number and lift and pitching moment coefficients. Linear lofting is used between airfoil stations. Solutions for isolated transport wings have shown that the solution is unique, and that including profile drag effects decreases tip loading and incidence relative to values obtained for minimum induced drag solutions. Further, including effects of variation of profile drag with Reynolds number can cause appreciable changes in the optimal design for tapered wings. Example solutions are also discussed for multiple planform configurations.

Kuhlman, J. M.↗

Aerodynamic data banks for Clark-Y, NACA 4-digit and NACA 16-series airfoil families

With the renewed interest in propellers as means of obtaining thrust and fuel efficiency in addition to the increased utilization of the computer, a significant amount of progress was made in the development of theoretical models to predict the performance of propeller systems. Inherent in the majority of the theoretical performance models to date is the need for airfoil data banks which provide lift, drag, and moment coefficient values as a function of Mach number, angle-of-attack, maximum thickness to chord ratio, and Reynolds number. Realizing the need for such data, a study was initiated to provide airfoil data banks for three commonly used airfoil families in propeller design and analysis. The families chosen consisted of the Clark-Y, NACA 16 series, and NACA 4 digit series airfoils. The various component of each computer code, the source of the data used to create the airfoil data bank, the limitations of each data bank, program listing, and a sample case with its associated input-output are described. Each airfoil data bank computer code was written to be used on the Amdahl Computer system, which is IBM compatible and uses Fortran.

Korkan, K. D.↗

Exact and approximate gas dynamics using the tangent gas

For the determination of aerodynamic characteristics such as lift, drag, and moment coefficients, it is crucial to compute the properties of steady flow past an airfoil. This investigation provides a set of flow dependent grid systems and initial flowfield guesses which substantially improve convergence rates when applied to the Euler equations for flows past an airfoil. The basic equations are examined, taking into account nonlinear equations which are difficult to solve. A good approximation to these equations under certain conditions can be obtained by introducing the so-called 'tangent gas approximation' considered by Woods (1961), in which the isentropic relation between rho and p is replaced by a tangent to a curve. Attention is given to the solution procedure, the analysis (direct) problem, and a comparison of the tangent gas solution with the converged Euler solution.

Daripa, P. K.↗

VSAERO analysis of structurally decoupled tip planforms for a semispan wing

A numerical analysis has been conducted with the three-dimensional panel code VSAERO for two interacting lifting surfaces that are separated in the spanwise direction by a narrow gap, with the angle of attack of the outboard section being set independently of the inboard section, as in the 'free tip' rotor blade system proposed for helicopters. Computed values of tip surface lift and pitching moment coefficients are correlated with experimental data to determine the most suitable method for modeling the gap region between the surfaces. It is shown that the induced drag of the tip surface is reduced for negative incidence angles relative to the inboard section.

Martin, Daniel M.↗

Experimental measurements in a large separation bubble due to a simulated glaze ice shape

The effect of a simulated glaze ice accretion on the aerodynamic performance of a NACA 0012 airfoil was studied experimentally. Two ice shapes were tested, one from an experimentally measured accretion and one from an accretion predicted using a computer model given the same icing conditions. Lift, drag and moment coefficients were measured for the airfoil with both ice shapes, smooth and rough. The aerodynamic performance of the two shapes compared well at positive, but not negative, angles of attack. Split hot-film probe velocity data were presented in the upper surface boundary layer and in the wake. Boundary layer parameters were presented for the separation bubble and in the reattached turbulent boundary layer.

Bragg, M. B.↗

Compressible studies on dynamic stall

The purpose of this work is to investigate the effects of compressibility on the dynamic stall phenomenon by numerical simulation of the unsteady flow. The full two-dimensional unsteady compressible Navier-Stokes equations are solved for flows over oscillating airfoils and airfoils pitching rapidly to high angles of attack. The free-stream speeds vary from low subsonic with mild compressibility effects, to moderate subsonic where strong compressibility effects appear close to the leading edge at high angles of attack. An Alternating Direction Implicit scheme is implemented for the numerical solution with the viscous terms retained in both directions. The numerical results are compared with available experimental data for a Sikorsky airfoil for compressible high Reynolds number flows. There is good agreement between the computed and measured unsteady lift and pitching moment coefficient time histories. The computed high-speed subsonic unsteady results give a good picture of the entire flow field, and the dynamic stall progression in the compressible flow regime. It was observed that compressibility effects are more severe close to the leading edge at moderate angles of attack, and that the dynamic stall vortex appears at lower angles of attack as the free-stream speed increases.

Ekaterinaris, J. A.↗

Effects of soil and canopy characteristics on microwave backscattering of vegetation

A frequency modulated continuous wave C-band (4.8 GHz) scatterometer was mounted on an aerial lift truck and backscatter coefficients of corn were acquired as functions of polarizations, view angles, and row directions. As phytomass and green leaf area index increased, the backscatter also increased. Near anthesis when the canopies were fully developed, the major scattering elements were located in the upper 1 m of the 2.8 m tall canopy and little backscatter was measured below that level. C-band backscatter data could provide information to monitor vegetation at large view zenith angles.

Daughtry, C. S. T.↗

Longitudinal aerodynamic characteristics of a subsonic, energy-efficient transport configuration in the National Transonic Facility

The Reynolds number, aeroelasticity, boundary layer transition, and nonadiabatic wall temperature effects, and data repeatability was determined in the National Transonic Facility (NTF) for a subsonic, energy efficient transport model. The model was tested over a Mach number range of 0.50 to 0.86 and a Reynolds number range of 1.9 million to approximately 23.0 million (based on mean geometric chord). The majority of the data was taken using cryogenic nitrogen (data at 1.9 million Reynolds number was taken in air). Force and moment, wing pressure, and wing thermocouple data are presented. The data indicate that increasing Reynolds number resulted in greater effective camber of the supercritical wing and horizontal tail, resulting in greater lift and pitching moment coefficients at nearly all angles of attack for M = 0.82. As Reynolds number was increased, untrimmed L/D increased, the angle of attack for maximum L/D decreased, drag creep was reduced significantly, and drag divergence Mach number increased slightly. Data repeatability for both modes of operation of the NTF (air and cryogenic nitrogen) was generally very good, and nonadiabatic wall effects were estimated to be small. Transition-free and transition-fixed configurations had significantly different force and moment data at M = 0.82 for low Reynolds number, and very small differences were noted at high Reynolds numbers.

Jacobs, Peter F.↗

C-band backscattering from corn canopies

A frequency-modulatad continuous-wave C-band (4.8 GHz) scatterometer was mounted on an aerial lift truck, and backscatter coefficients of corn (Zea mays L.) were acquired as functions of polarizations, view angles, and row directions. As phytomass and green-leaf area index increased, the backscatter also increased. Near anthesis, when the canopies were fully developed, the major scattering elements were located in the upper 1 m of the 2.8 m tall canopy and little backscatter was measured below that level for view angles of 30 deg or greater. C-band backscatter data could provide information to monitor tillage operations at small view zenith angles and vegetation at large view zenith angles.

Daughtry, C. S. T.↗

Experimental study of performance degradation of a rotating system in the NASA Lewis RC icing tunnel

The Helicopter Icing Consortium (HIC) conducted one of the first U.S. tests of a heavily instrumented model in the controlled environment of a refrigerated tunnel. In the Icing Research Tunnel (IRT) at NASA LeRC, ice was accreted on the main rotor blade of the BMTR-1 Sikorsky model helicopter under a variety of environmental conditions, such that liquid water content (LWC) and volume mean droplet diameter (VMD) ranges reflected the Federal Aviation Agency and Department of Defence icing condition envelopes. This report gives the correlated results of the data provided by NASA LeRC. The method of statistical analysis is discussed. Lift, thrust, and torque coefficients are presented as a function of icing time, as correlated with changes in ambient temperature, LWC, and VMD. The physical significance of these forces is discussed.

Korkan, Kenneth↗

Stability and control of hypersonic waveriders

The longitudinal and lateral stability derivatives of caret-wing waveriders flying on-design are calculated using linear piston theory. The experimental work of Kipke is used to validate the lift and pitch stiffness coefficients. Comparison is also made to the analytical work done by Hui. The calculations are extended to off-design conditions with an attached shock wave using tangent wedge theory. The stability derivatives of a Mach 6 waverider are computed and conclusions about its stability are drawn.

Tarpley, Christopher↗

Comparative wind tunnel tests at high Reynolds numbers of NACA 64 621 airfoils with two aileron configurations

An experimental program to measure the aerodynamic characteristics of the NACA 64-621 airfoil when equipped with plain ailerons of 0.38 chord and 0.30 chord and with 0.38 chord balanced aileron has been conducted in a pressurized 6 x 12-inch High Reynolds Number Wind Tunnel. Surface pressures were measured and integrated to yield lift and pressure drag coefficients for angles of attack from -3 deg to +42 deg, and for selected aileron deflections from 0 to -90 deg at nominal Mach and Reynolds numbers of 0.25 and 5 x l0 exp 6, respectively. When resolved into thrust coefficient for wind turbine aerodynamic control applications, the data indicated the anticipated decrease in thrust coefficient with negative aileron deflection at low angles of attack; however, as angle of attack increased, thrust coefficients eventually became positive. All aileron configurations, even at -90 deg deflections, showed this trend. Hinge moments for each configuration complete the data set.

Gregorek, G. M.↗

Landing characteristics of an autogiro

An investigation to determine the rate of descent, the horizontal velocity, and the attitude at contact of an autogiro in landings was made by the National Advisory Committee for Aeronautics at the request of the Bureau of Air Commerce, Department of Commerce. The investigation covered various types of landings. The results of the investigation disclosed that the maximum rate of descent at contact with the ground (10.6 feet per second) was less than the minimum rate of descent attainable in a steady glide (15.8 feet per second); that the rates of descent at contact were of the same order of magnitude as those experienced by conventional airplanes in landings; that flared landings resulted in very low horizontal velocities at contact. Also that unexpectedly high lift and drag force coefficients were developed in the latter stages of the flared landings.

Peck, William C↗

Speed limits of aircraft

This paper is restricted to the question of attainable speed limits and attacks the problem from different angles. Theoretical limits due to air resistance are presented along with design factors which may affect speed such as wing loads, wing areas, wing section shifting, landing speeds, drag-lift ratios, and power coefficients.

Everling, E↗

Comparative wind tunnel test at high Reynolds numbers of NACA 64 621 airfoils with two aileron configurations

An experimental program to measure the aerodynamic characteristics of the NACA 64-621 airfoil when equipped with plain ailerons of 0.38 chord and 0.30 chord and with 0.38 chord balanced aileron has been conducted in the pressurized O.S.U. 6 x 12 ft High Reynolds Number Wind Tunnel. Surface pressures were measured and integrated to yield lift and pressure drag coefficients for angles of attack from -3 to +42 deg and for selected aileron deflections from 0 to -90 deg at nominal Mach and Reynolds numbers of 0.25 and 5 x 10(exp 6). When resolved into thrust coefficient for wind turbine aerodynamic control applications, the data indicated the anticipated decrease in thrust coefficient with negative aileron deflection at low angles of attack; however, as angle of attack increased, thrust coefficients eventually became positive. All aileron configurations, even at -90 deg deflections showed this trend. Hinge moments for each configuration complete the data set.

Gregorek, G. M.↗

Predicted Aerodynamic Characteristics of a NACA 0015 Airfoil Having a 25% Integral-Type Trailing Edge Flap

Using the two-dimensional ARC2D Navier-Stokes flow solver analyses were conducted to predict the sectional aerodynamic characteristics of the flapped NACA-0015 airfoil section. To facilitate the analyses and the generation of the computational grids, the airfoil with the deflected trailing edge flap was treated as a single element airfoil with no allowance for a gap between the flap's leading edge and the base of the forward portion of the airfoil. Generation of the O-type computational grids was accomplished using the HYGRID hyperbolic grid generation program. Results were obtained for a wide range of Mach numbers, angles of attack and flap deflections. The predicted sectional lift, drag and pitching moment values for the airfoil were then cast in tabular format (C81) to be used in lifting-line helicopter rotor aerodynamic performance calculations. Similar were also generated for the flap. Mathematical expressions providing the variation of the sectional lift and pitching moment coefficients for the airfoil and for the flap as a function of flap chord length and flap deflection angle were derived within the context of thin airfoil theory. The airfoil's sectional drag coefficient were derived using the ARC2D drag predictions for equivalent two dimensional flow conditions.

Hassan, Ahmed↗