Search NASA⌕ Search

SEARCH · Search NASA

Results for “error estimate”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 1,099 records · Page 61

Minimax failure detection and identification in redundant gyro and accelerometer systems.

Minimax algorithms for failure detection and identification for redundant noncolinear arrays of single-degree-of-freedom gyros and accelerometers are described. These algorithms are optimum in the sense that detection occurs as soon as it is no longer possible to account for the instrument outputs as the outputs of good instruments operating within their noise tolerances, and identification occurs as soon as it is true that only a particular instrument failure could account for the actual instrument outputs within the noise tolerance of good instruments. An estimation algorithm is described which minimizes the maximum possible estimation error magnitude for the given set of instrument outputs. Monte Carlo simulation results are presented for the application of the algorithms to an inertial reference unit consisting of six gyros and six accelerometers in two alternate configurations.

Potter, J. E.↗

Optical constants of concentrated aqueous ammonium sulfate.

Using experimental data obtained from applying spectroscopy to a 39-wt-% aqueous ammonium sulfate solution, it is shown that, even though specific aerosol optical constants appear quite accurate, spectral variations may exist as functions of material composition or concentration or both. Prudent users of optical constant data must then include liberal data error estimates when performing calculations or in interpreting spectroscopic surveys of collected aerosol material.

Remsberg, E. E.↗

Role of gas-surface interactions in the reduction of Ogo 6 neutral particle mass spectrometer data.

Data obtained with the quadrupole mass spectrometer aboard the Ogo 6 satellite show the effects of significant surface interaction processes, including nearly complete recombination of incoming atomic oxygen on the walls of the instrument antechamber plus adsorption and desorption of oxygen and carbon monoxide. The observed data are fit by solving the time-dependent continuity equations accounting for production and loss of atomic oxygen, molecular oxygen, and (in the case of mass 28) carbon monoxide. The surface parameters that best fit the data are selected and applied to the determination of ambient densities and their estimated errors.

Hedin, A. E.↗

Micro-organism distribution sampling for bioassays

Purpose of sampling distribution is to characterize sample-to-sample variation so statistical tests may be applied, to estimate error due to sampling (confidence limits) and to evaluate observed differences between samples. Distribution could be used for bioassays taken in hospitals, breweries, food-processing plants, and pharmaceutical plants.

Nelson, B. A.↗

A Catalogue of Galaxies Having Radial Velocities: Volume 15: Part 7

A tabulation of galaxies which have radial velocities is presented. The parameters of each galaxy are: (1) an abbreviation for the catalog designation, (2) RA(1950), (3) Dec. (1950), (4) new galactic longitude, (5) new galactic latitude, (6) morphological type, (7) magnitude, (8) observed radial velocity in kilometers per second (9) radial velocity corrected for solar motion, and (10) estimated error in radial velocity in kilometers per second.

Fredrick, L. W.↗

Changing stepsize in the integration of differential equations using modified divided differences

Multistep methods for solving differential equations based on numerical integration formulas or numerical differentiation formulas (for stiff equations) require special provision for changing the stepsize. New algorithms are given which make the use of modified divided differences an attractive way to carry out the change in stepsize for such methods. Error estimation and some of the important factors in stepsize selection and the selection of integration order are also considered.

Krogh, F. T.↗

Algorithm for nonlinear stationary Navier-Stokes problem

Results of applications of algorithm suggest that it has potential application to variety of related fluid flow problems, such as presently intractable separation problem of aerodynamics. Details of mathematical development, as well as computation of explicit error estimates, are available.

Gabrielsen, R. E.↗

Sea surface determination from space: The GSFC geoid

The determination of the sea surface/geoid and its relative variation were investigated and results of the altimeter experiment on Skylab to test the geoid are discussed. The spaceborne altimeter on Skylab revealed that the sea surface of the world's oceans can be measured with an accuracy in the meter range. Surface variations are discussed as they relate to those computed from satellite orbital dynamics and ground based gravity data. The GSFC geoid was constructed from about 400,000 satellite tracking data (range, range rate, angles) and about 20,000 ground gravity observations. One of the last experiments on Skylab was to measure and/or test this geoid over almost one orbit. It was found that the computed water surface deviates between 5 to 20 m from the measured one. Further outlined are the influence of orbital errors on the sea surface, and numerical examples are given based upon real tracking data. Orbital height error estimates were computed for geodetic type satellites and are found to be in the order of 0.2 to 5 meters.

Vonbun, F. O.↗

C-band station coordinate determination for the Geos-C altimeter calibration area

Dynamical orbital techniques were employed to estimate the center-of-mass station coordinates of six C-band radars located in the designated primary Geos-C radar altimeter calibration area. This work was performed in support of the planned Geos-C mission (December 1974 launch). The sites included Bermuda, Grand Turk, Antigua, Wallops Island (Virginia), and Merritt Island (Florida). Two sites were estimated independently at Wallops Island yielding better than 40 cm relative height recovery, with better than 10 cm and 1m (relative) recovery for phi and lambda, respectively. The tracking data used in this analysis were taken during 1969 when the radars tracked the Geos-II transponder. In all, over 120 passes of data were used. Range biases were estimated. Error analysis and comparisons with other investigators indicate that better than 2m (1 sigma) relative recovery has been achieved at all sites.

Klosko, S. M.↗

Kinetics of the reaction OH + D yields OD + H

The reaction of OH radicals with D-atoms to form OD has been studied at room temperature in a discharge-flow system utilizing UV resonance fluorescence detection of the molecular species. A rate constant of approximately 1.3 by 10 to the -10th power cu cm per sec is reported where the error limits include systematic error estimates. Astrophysical and kinetic implications are discussed briefly.

Margitan, J. J.↗

Stochastic models for software project management

A method for determining the number and characteristics of milestones to be achieved during a development project is presented in order that effective monitors of progress can be provided. Projections of progress data lead to estimates of the completion with determinable accuracy, but accuracy imposes a requirement that the number of milestones be inversely proportional to the estimate-error variance, and that the milestones themselves be defined in such a way that each represents approximately the same level of effort to complete.

Tausworthe, R. C.↗

Algorithms for adaptive stochastic control for a class of linear systems

Control of linear, discrete time, stochastic systems with unknown control gain parameters is discussed. Two suboptimal adaptive control schemes are derived: one is based on underestimating future control and the other is based on overestimating future control. Both schemes require little on-line computation and incorporate in their control laws some information on estimation errors. The performance of these laws is studied by Monte Carlo simulations on a computer. Two single input, third order systems are considered, one stable and the other unstable, and the performance of the two adaptive control schemes is compared with that of the scheme based on enforced certainty equivalence and the scheme where the control gain parameters are known.

Toda, M.↗

The Mechanics of Atmospheric Systems Derived Through Vertical and Horizontal Analysis of Parametric Data

For 36 hours during April 1975, an atmospheric variability experiment was conducted. This research effort supported an observational program in which rawinsonde data, radar data, and satellite data were collected from a network of 42 stations east of the Rocky Mountains at intervals of 3 hours. This program presents data with a high degree of time resolution over a spatially and temporally extensive network. Reduction of the experiment data is intended primarily as a documentation of the checking and processing of the data and should be useful to prospective users. Various flow diagrams of the data processing procedures are described, and a complete summary of the formulas used in the data processing is provided. A wind computation scheme designed to extract as much detailed wind information as possible from the unique experiment data set is discussed. The accuracy of the thermodynamic and wind data were estimated. Errors in the thermodynamic and wind data are given.

Turner, R. E.↗

The discrete-time compensated Kalman filter

A suboptimal dynamic compensator to be used in conjunction with the ordinary discrete time Kalman filter was derived. The resultant compensated Kalman Filter has the property that steady state bias estimation errors, resulting from modelling errors, were eliminated.

Lee, W. H.↗

Three-dimensional effects on pure tone fan noise due to inflow distortion

Two dimensional, quasi three dimensional and three dimensional theories for the prediction of pure tone fan noise due to the interaction of inflow distortion with a subsonic annular blade row were studied with the aid of an unsteady three dimensional lifting surface theory. The effects of compact and noncompact source distributions on pure tone fan noise in an annular cascade were investigated. Numerical results show that the strip theory and quasi three-dimensional theory are reasonably adequate for fan noise prediction. The quasi three-dimensional method is more accurate for acoustic power and model structure prediction with an acoustic power estimation error of about plus or minus 2db.

Kobayashi, H.↗

Estimation of snow temperature and mean crystal radius from remote multispectral passive microwave measurements

Variation in crystal size and physical temperature of snowfield observations from space give large variations in the microwave brightness temperature. Since the brightness temperature is a function of wavelength, the microwave brightness temperature can be used to extract the snow temperature and mean crystal radius profiles. The Scanning Multichannel Microwave Radiometer (SMMR), to be launched on board the Nimbus-G and Seasat-A spacecraft, will make observations in wavelengths of 0.8, 1.4, 1.7, 2.8, and 4.6 cm. A statistical retrieval method was developed to determine the snowfield temperature profile and mean crystal size by using the scanning multifrequency microwave radiometer on board a spacecraft. The estimated errors for retrieval are approximately 1.5 K for temperature and 0.001 for crystal radius in the presence of 1 K rms noise for each SMMR channel.

Chang, A. T. C.↗