Search NASA⌕ Search

SEARCH · Search NASA

Results for “CONTROL, LONGITUDINAL”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 145 records · Page 8
All sourcesNASA NTRSDOE OSTI
NASA NTRS1990

An in-flight interaction of the X-29A canard and flight control system

This paper presents the details of an aeroservoelastic interaction experienced in flight by the X-29A forward-swept-wing aircraft. A 26.5-Hz canard pitch-mode response was aliased by the digital sampling rate in the canard-position feed-back loop of the flight-control system, resulting in a 13.5-Hz signal being commanded to the longitudinal control surfaces. The amplitude of this commanded signal increased as the wear of the canard seals increased, as the feedback path gains were increased, and as the canard aerodynamic loading decreased. The resultant control-surface deflections were of sufficient amplitude to excite the structure. The flight data presented shows the effect of each component (structural dynamics, aerodynamics, and flight-control system) for this aeroservoelastic interaction.

Kehoe, Michael W.↗
NASA NTRS1999

X-33 Hypersonic Aerodynamic Characteristics

Lockheed Martin Skunk Works, under a cooperative agreement with NASA, will build and fly the X-33, a half-scale prototype of a rocket-based, single-stage-to-orbit (SSTO), reusable launch vehicle (RLV). A 0.007-scale model of the X-33 604B0002G configuration was tested in four hypersonic facilities at the NASA Langley Research Center to examine vehicle stability and control characteristics and to populate an aerodynamic flight database i n the hypersonic regime. The vehicle was found to be longitudinally controllable with less than half of the total body flap deflection capability across the angle of attack range at both Mach 6 and Mach 10. At these Mach numbers, the vehicle also was shown to be longitudinally stable or neutrally stable for typical (greater than 20 degrees) hypersonic flight attitudes. This configuration was directionally unstable and the use of reaction control jets (RCS) will be necessary to control the vehicle at high angles of attack in the hypersonic flight regime. Mach number and real gas effects on longitudinal aerodynamics were shown to be small relative to X-33 control authority.

Murphy, Kelly J.↗
NASA NTRS1972

Development of approach control system requirements with applications to a jet transport

The development of requirements for an approach control system and example applications to a jet transport aircraft are presented. The material is divided into a general discussion of approach control requirements, and a specific application resulting in the design of three alternative longitudinal controllers. The point of view taken is that the essential features of the system structure are the feedbacks themselves, their equalization, and their combinations to create control commands. Use is made of the fact that for sucessful systems the possible feedback structures are very limited. They derive primarily from guidance, control, and regulation demands; and secondarily from dynamic response characteristics desired by the pilot. From the systems view it is the satisfaction of these requirements that is important rather than the means automatic, manual, or hygrid manual/automatic approach systems.

Mcruer, D. T.↗
NASA NTRS1972

Preliminary results of flight tests of the augmentor-wing jet STOL research aircraft

The Augmentor-Wing Jet STOL Research Aircraft has been developed and has started flight tests. The objectives of the program are to compare aerodynamic characteristics predicted from wind-tunnel data with data obtained in flight, to determine flight dynamic characteristics and limitations of the augmentor-wing concepts, and to contribute to the development of STOL design and operational criteria. Initial flight test results have shown that the aerodynamic characteristics are close to values predicted from wind-tunnel tests. The lateral-directional stability and control characteristics are satisfactory for research STOL missions with stability augmentation, but the longitudinal control require improvement. STOL take-off distance over 11 m is about 290 m, and landing approach speeds are between 60 and 65 knots. The investigation of the STOL operational and performance characteristics is continuing.

Quigley, H. C.↗
NASA NTRS1993

Design of a flight control system for a highly maneuverable aircraft using mu synthesis

This paper presents a methodology for the design of longitudinal controllers for high performance aircraft operating over large ranges of angle of attack. The technique used for controller design is structured singular value or mu synthesis. The controller is designed to minimize the weighted H-infinity norm of the error between the aircraft response and the desired handling quality specifications without saturating the control actuators. The mu synthesis procedure ensures that the stability and performance of the aircraft is robust to parameter variations and modeling uncertainties included in the design model. Nonlinear simulations demonstrate that the controller satisfies handling quality requirements and provides excellent tracking of pilot inputs over a wide range of transient angles of attack and Mach number.

Reiner, Jacob↗
NASA NTRS1971

Analytic evaluation of display requirements for approach to landing

A computerized analysis procedure, based on a control theoretic model of the human pilot, is used to evaluate display requirements for longitudinal control in the landing approach. The display employed a digitally generated, perspective runway image with a superimposed artificial horizon for pitch indication. System performance measures are obtained for the approach phase of a light aircraft and a DC-8; predictions are made as to the effects of several display modifications. It is found that augmenting the basic display with glide slope reference bars and a velocity aim point yields adequate performance in calm air. Under moderate turbulence, the augmented display appears to be adequate for a DC-8 approach but not for a light aircraft.

Kleinman, D. L.↗
NASA NTRS1991

Final design proposal: Theta Group-The Hotbox. A proposal in response to a commercial air transportation study

The Hotbox is a 40 passenger commercial aircraft designed to have a minimum range of 5500 ft and cruise at a velocity of 30 ft/sec. The aircraft is designed to serve the longer range overseas market in Aeroworld. In order to serve all the airports in the overseas market, the Hotbox was required to be able to use a five foot gate. A weight requirement was set a 4.5 lbs in order to maximize aircraft efficiency. Finally, a single engine system was chosen because it minimized system weight, complexity and cost. The Hotbox is estimated to cost $152,000 Aeroworld dollars and will sell for $200.000. The propulsion system for the Hotbox consists of a nose mounted Astro 15 electric powered motor and a Top Flight 12-6 propeller. A Spica airfoil was selected for the Hotbox based on the ease of construction of its flat bottom and its positive lift and drag characteristics. A fuselage of rectangular cross section will internally contain the propulsion system, control system, and a passenger bay with 2x20 seating. A combination of directional and longitudinal control will enable the Hotbox to maneuver. The final design of the Hotbox provides for takeoff distance in 26.5 ft and normal cruise range of 17,000 ft.

Source record↗
NASA NTRS1976

Wind-tunnel tests of a 1/4 scale model of the Bell XS-1 transonic airplane. 1: Longitudinal stability and control characteristics

A 1/4 scale model of the Bell XS-1 transonic aircraft was tested in the Langley 300 mile-per-hour 7 by 10 foot tunnel to determine its low speed longitudinal stability and control characteristics. Pertinent longitudinal flying qualities expected of the XS-1 research airplane were estimated from the results of these tests including the effects of compressibility likely to be encountered at speeds below the force break. It appears that the static longitudinal stability and elevator control power will be adequate, but that the elevator control force gradient in steady flight will be undesirably low for all configurations. It is suggested that a centering spring be incorporated in the elevator control system of the airplane in order to increase the control force gradient in steady flight and in maneuvers.

Donlan, C. J.↗
NASA NTRS1988

General-Aviation Control Loader

Artificial-feel system designed for general-aviation flight simulators. New system developed to replace directly lateral and longitudinal controls in general-aviation cockpit for use in flight-simulation research. Using peaucellier's cell to convert linear motion to rotary motion, control-loading system provides realistic control-force feedback to cockpit wheel and column controls.

Baltrus, Daniel W.↗
NASA NTRS1959

Launch, Low-Speed, and Landing Characteristics Determined from the First Flight of the North American X-15 Research Airplane

The first flight of the North American X-15 research airplane was made on June 8, 1959. This was accomplished after completion of a series of captive flights with the X-15 attached to the B-52 carrier airplane to demonstrate the aerodynamic and systems compatibility of the X-15//B-52 combination and the X-15 subsystem operation. This flight was planned as a glide flight so that the pilot need not be concerned with the propulsion system. Discussions of the launch, low-speed maneuvering, and landing characteristics are presented, and the results are compared with predictions from preflight studies. The launch characteristics were generally satisfactory, and the X-15 vertical tail adequately cleared the B-52 wing cutout. The actual landing pattern and landing characteristics compared favorably with predictions, and the recommended landing technique of lowering the flaps and landing gear at a low altitude appears to be a satisfactory method of landing the X-15 airplane. There was a quantitative correlation between flight-measured and predicted lift-drag-ratio characteristics in the clean configuration and a qualitative correlation in the landing configuration. A longitudinal-controllability problem, which became severe in the landing configuration, was evident throughout the flight and, apparently, was aggravated by the sensitivity of the side-located control stick. In the low-to-moderate angle-of-attack range covered, the longitudinal and directional stability were indicated to be adequate.

Finch, Thomas W.↗
NASA NTRS2013

A Model of Manual Control with Perspective Scene Viewing

A model of manual control during perspective scene viewing is presented, which combines the Crossover Model with a simpli ed model of perspective-scene viewing and visual- cue selection. The model is developed for a particular example task: an idealized constant- altitude task in which the operator controls longitudinal position in the presence of both longitudinal and pitch disturbances. An experiment is performed to develop and vali- date the model. The model corresponds closely with the experimental measurements, and identi ed model parameters are highly consistent with the visual cues available in the perspective scene. The modeling results indicate that operators used one visual cue for position control, and another visual cue for velocity control (lead generation). Additionally, operators responded more quickly to rotation (pitch) than translation (longitudinal).

pilot modeling↗
NASA NTRS1994

A nonlinear strategy for sensor based vehicle path control

A method of transverse control which makes use of nonlinear formulations is presented. The strategy is utilized to stabilize a vehicle. The vehicle is autonomously guided and takes its control inputs from an optical sensing system. Additionally, the velocity of the vehicle is dictated by a longitudinal controller, which is also discussed.

Mayr, R.↗
NASA NTRS1980

Simulation development and evaluation of an improved longitudinal velocity vector control wheel steering mode and electronic display format

Using simulation, an improved longitudinal velocity vector control wheel steering mode and an improved electronic display format for an advanced flight system were developed and tested. Guidelines for the development phase were provided by test pilot critique summaries of the previous system. The results include performances from computer generated step column inputs across the full airplane speed and configuration envelope, as well as piloted performance results taken from a reference line tracking task and an approach to landing task conducted under various environmental conditions. The analysis of the results for the reference line tracking and approach to landing tasks indicates clearly detectable improvement in pilot tracking accuracy with a reduction in physical workload. The original objectives of upgrading the longitudinal axis of the velocity vector control wheel steering mode were successfully met when measured against the test pilot critique summaries and the original purpose outlined for this type of augment control mode.

Steinmetz, G. G.↗
NASA NTRS2000

An Entry Flight Controls Analysis for a Reusable Launch Vehicle

The NASA Langley Research Center has been performing studies to address the feasibility of various single-stage to orbit concepts for use by NASA and the commercial launch industry to provide a lower cost access to space. Some work on the conceptual design of a typical lifting body concept vehicle, designated VentureStar(sup TM) has been conducted in cooperation with the Lockheed Martin Skunk Works. This paper will address the results of a preliminary flight controls assessment of this vehicle concept during the atmospheric entry phase of flight. The work includes control analysis from hypersonic flight at the atmospheric entry through supersonic speeds to final approach and landing at subsonic conditions. The requirements of the flight control effectors are determined over the full range of entry vehicle Mach number conditions. The analysis was performed for a typical maximum crossrange entry trajectory utilizing angle of attack to limit entry heating and providing for energy management, and bank angle to modulation of the lift vector to provide downrange and crossrange capability to fly the vehicle to a specified landing site. Sensitivity of the vehicle open and closed loop characteristics to CG location, control surface mixing strategy and wind gusts are included in the results. An alternative control surface mixing strategy utilizing a reverse aileron technique demonstrated a significant reduction in RCS torque and fuel required to perform bank maneuvers during entry. The results of the control analysis revealed challenges for an early vehicle configuration in the areas of hypersonic pitch trim and subsonic longitudinal controllability.

Calhoun, Philip↗
NASA NTRS1981

Saturn's radio emissions - Rotational modulation

Observational data provided by Pioneer 11 and Voyager 1 have revealed that the Saturnian ring system has important effects on the structures of the planetary ionosphere as well as the magnetospheric environment, such as the unexpected rotational modulation of the Saturn kilometric radiation (SKR) and the Saturn electrostatic discharge (SED) as discovered by the Voyager planetary radio astronomy experiment. The challenge arises to devise a mechanism which can produce electrodynamic coupling between the ring system and the planetary ionosphere and/or magnetosphere in which the associated SKR and SED radio emissions are subject to longitudinal control. One candidate is the establishment of field-aligned current systems, connecting the rings and the ionosphere with longitudinal variation. Local acceleration processes in the vicinity of the rings are also needed. The interplay between the ring-current systems and the geometry of the dipole field and the rings is discussed, and a description is presented of some of the basic ingredients in the longitudinal modulations of SKR and SED.

Goertz, C. K.↗
NASA NTRS1960

Flight Investigation of an Automatic Pitchup Control

A flight investigation of an automatic pitchup control has been conducted by the National Aeronautics and Space Administration at the Langley Research Center. The pitching-moment characteristics of a transonic fighter airplane which was subject to pitchup were altered by driving the stabilizer in accordance with a signal that was a function of a combination of the measured angle of attack and the pitching velocity. An angle-of-attack threshold control was used to preset the angle of attack at which the automatic pitchup-control system would begin to drive the stabilizer. No threshold control as such existed for the pitching-velocity signal. A summing linkage in series with the pilot's longitudinal control allowed the automatic pitchup-control system to drive the stabilizer 13.5 percent of the total stabilizer travel independently of the pilot's control. Tests were made at an altitude of 35,000 feet over a Mach number range of 0.80 to 0.90. Various gearings between the control and the sensing devices were investigated. The automatic system was capable of extending the region of positive stability for the test airplane to angles of attack above the basic-airplane pitchup threshold angle of attack. In most cases a limit-cycle oscillation about the airplane pitch axis occurred.

Hurt, George J., Jr.↗
NASA NTRS1954

Longitudinal Stability and Control Characteristics at Transonic Speeds of a 1/30-Scale Model of the Republic XF-103 Airplane

The longitudinal stability and control characteristics of a 1/30-scale model of the Republic XF-103 airplane were investigated in the Langley 8-foot transonic tunnel. The effect of speed brakes located at the end of the fuselage was also investigated. The main part of the investigation was made with internal flow in the model, but some data were obtained with no internal flow. The longitudinal stability and control at transonic-speeds appeared satisfactory. The transonic drag rise was small. The speed brakes had no adverse effects on longitudinal stability.

Luoma, Arvo A.↗