Search NASA⌕ Search

SEARCH · Search NASA

Results for “Padding”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 1,459 records · Page 81

The Explorer Rocket Research Program

Since September of 1956, nine Jupiter-C missiles have been launched from the firing pad at Cape Canaveral. The first Jupiter-C firing tested the propulsion system, air frame, and guidance components of the missile, and the second and third firings tested a model of the Jupiter nose cone under realistic re-entry conditions. The remaining six Jupiter-C missiles were used as the launching vehicles for EXPLORER satellites I through VI (Fig. 1). Of the six satellite firings, EXPLORERs I, III, and IV achieved satisfactory orbits. The Jupiter-C missile was designed and developed as a joint program under the technical direction of the Jet Propulsion Laboratory and the Army Ballistic Missile Agency. The Jet Propulsion Laboratory developed the three high-speed stages, and the Army Ballistic Missile Agency handled the development, construction, and operation of the first-stage booster rocket and the guidance system. Many other organizations have contributed to the success of the EXPLORER satellite program, most notably the State University of Iowa, the Air Force Cambridge Research Center, and the satellite tracking teams of the Vanguard organization.

Robillard, G.↗

Fixture aids soldering of electronic components on circuit board

Spring clamp fixture holds small electronic components in a desired position while they are being soldered on a circuit board. The spring clamp is clipped on the edge of the circuit board and an adjustable spring-steel boom holds components against the board. The felt pad at the end of the boom is replaced with different attachments for other holding tasks.

Ross, M. H.↗

Fixed vacuum plate clamps styrofoam for machining

Aluminum plate holds styrofoam securely in place for machining operations. The styrofoam is clamped to rubber or cork pads on the plate surface by vacuum. Foam rubber tape provides the vacuum seal.

Rauschl, J. A.↗

One-piece transparent shell improves design of helmet assembly

One-piece transparent helmet shell made of polycarbonate is equipped with a helmet protection pad, a visor assembly, a communications skull cap, and an emergency oxygen supply. This design offers improvements over previous designs in weight, visual field, comfort and protection.

Jones, R. L.↗

Resilient bearing supports are gas controlled

Self-acting, partial-arc, pivoted-pad bearings in which the bearing-to-journal applied load is pneumatically controlled are used in the operation of a radial flow gas generator where shaft speeds are on the order of 38,500 rpm.

Six, L. D.↗

Hand-operated plug insertion valve

Hand-operated plug insertion valve seals an evacuated insulation system for upper stage liquid hydrogen tanks on the launch pad. It is light in weight, demountable, and permits evacuation of the system plus sealing after evacuation.

Jones, R. G.↗

Tape reading fixture

Commercially available roller type desk pad provides an efficient and orderly manner of handling rolled paper tapes for proofreading. The fixture, which is modified to accept Flex-O-Writer or similar tapes and roll them in either direction, reduces the chance of damaging or soiling the tapes through repeated handling.

Source record↗

Tilt table for ergometers and other biomedical devices

Table adjusts to any position between horizontal and vertical. Apparatus includes - floor plate, plate hinged to floor plate, for carrying ergometer, hydraulic cylinder and piston on plate sides, linking them, hydraulic system, positive stops, padded backrest and headrest, one hand controls, and constraint system.

Gause, R. L.↗