Search NASASearch

SEARCH · Search NASA

Results for “current drive”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 19 records

Reconfigurable Drive Current System

A reconfigurable drive current system includes drive stages, each of which includes a high-side transistor and a low-side transistor in a totem pole configuration. A current monitor is coupled to an output of each drive stage. Input channels are provided to receive input signals. A processor is coupled to the input channels and to each current monitor for generating at least one drive signal using at least one of the input signals and current measured by at least one of the current monitors. A pulse width modulation generator is coupled to the processor and each drive stage for varying the drive signals as a function of time prior to being supplied to at least one of the drive stages.

Alhorn, Dean C.

Improved High-Current Drive Circuit

Uses VMOS field-effect power transistor. High-current drive circuit employs n-channel enhancement-mode VMOS field-effect power transistor to eliminate problem of oscillation at high power encountered in conventional circuits with bipolar transistors. Drive voltage required is typically 1 to 3 V for load current of 10 A.

Cole, S. W.

Clipper for High-Impedance Current-Drive Line

New circuit leakage reduced by shunting current through saturated input at operational-amplifier follower already part of Howland, or equivalent, current source. Typical application is in circuit of germanium resistance thermometer in cryogenic system.

Woodhouse, Christopher E.

Redundant drive current imbalance problem of the Automatic Radiator Inspection Device (ARID)

The Automatic Radiator Inspection Device (ARID) is a 4 Degree of Freedom (DOF) robot with redundant drive motors at each joint. The device is intended to automate the labor intensive task of space shuttle radiator inspection. For safety and redundancy, each joint is driven by two independent motor systems. Motors driving the same joint, however, draw vastly different currents. The concern was that the robot joints could be subjected to undue stress. It was the objective of this summer's project to determine the cause of this current imbalance. In addition it was to determine, in a quantitative manner, what was the cause, how serious the problem was in terms of damage or undue wear to the robot and find solutions if possible. It was concluded that most problems could be resolved with a better motor control design. This document discusses problems encountered and possible solutions.

Latino, Carl D.

Direct-current drive for ac motors

Dual windings of ac motor serve as output transformer for dc/ac inversion. Method makes use of low-cost commutatorless ac motors, powered by solar energy, batteries and other dc sources possible.

Solario, J. N.

Level Sensor for Cryogenic Fluids

Hot wire sensor combined with voltage-comparator circuit monitors liquid level in cryogenic-fluid storage tanks. Sensor circuit adaptable to different liquids and sensors. Constant-current source drives current through sensing probe and fixed resistor. Voltage comparator circuits interpret voltage drops to tell whether probe is immersed in liquid and is current in probe.

Simmons, N. E.

Electrical and optical study of semiconductor laser diodes and materials

The characterization of a 2-D diode laser array from McDonald Douglas has been completed. The array consisted of 8 linear arrays of approximately 11 mm x 0.18 mm. Each array has between 7 and 8 diodes per mm. The threshold current is approximately 15 amps. The power output vs drive current (above threshold) of the array was measured. A peak power of 50 W was obtained at a drive current of 26 amps. Its far field pattern has a double lobe.

Albin, Sacharia

Power-control switch

Constant-current source creates drive current independent of input-voltage variations, 50% reduction in power loss in base drive circuitry, maintains essentially constant charge rate, and improves rise-time consistency over input voltage range.

Kessler, L. L.

The Effects of Low Dose-Rate Ionizing Radiation on the Shapes of Transients in the LM124 Operational Amplifier

Shapes of single event transients (SETs) in a linear bipolar circuit (LM124) change with exposure to total ionizing dose (TID) radiation. SETs shape changes are a direct consequence of TID-induced degradation of bipolar transistor gain. A reduction in transistor gain causes a reduction in the drive current of the current sources in the circuit, and it is the lower drive current that most affects the shapes of large amplitude SETs.

Buchner, Stephen

2-D Modeling of Nanoscale MOSFETs: Non-Equilibrium Green's Function Approach

We have developed physical approximations and computer code capable of realistically simulating 2-D nanoscale transistors, using the non-equilibrium Green's function (NEGF) method. This is the most accurate full quantum model yet applied to 2-D device simulation. Open boundary conditions and oxide tunneling are treated on an equal footing. Electrons in the ellipsoids of the conduction band are treated within the anisotropic effective mass approximation. Electron-electron interaction is treated within Hartree approximation by solving NEGF and Poisson equations self-consistently. For the calculations presented here, parallelization is performed by distributing the solution of NEGF equations to various processors, energy wise. We present simulation of the "benchmark" MIT 25nm and 90nm MOSFETs and compare our results to those from the drift-diffusion simulator and the quantum-corrected results available. In the 25nm MOSFET, the channel length is less than ten times the electron wavelength, and the electron scattering time is comparable to its transit time. Our main results are: (1) Simulated drain subthreshold current characteristics are shown, where the potential profiles are calculated self-consistently by the corresponding simulation methods. The current predicted by our quantum simulation has smaller subthreshold slope of the Vg dependence which results in higher threshold voltage. (2) When gate oxide thickness is less than 2 nm, gate oxide leakage is a primary factor which determines off-current of a MOSFET (3) Using our 2-D NEGF simulator, we found several ways to drastically decrease oxide leakage current without compromising drive current. (4) Quantum mechanically calculated electron density is much smaller than the background doping density in the poly silicon gate region near oxide interface. This creates an additional effective gate voltage. Different ways to. include this effect approximately will be discussed.

Svizhenko, Alexei

Alternating-Current Motor Drive for Electric Vehicles

New electric drive controls speed of a polyphase as motor by varying frequency of inverter output. Closed-loop current-sensing circuit automatically adjusts frequency of voltage-controlled oscillator that controls inverter frequency, to limit starting and accelerating surges. Efficient inverter and ac motor would give electric vehicles extra miles per battery charge.

Krauthamer, S.

Dual mode solid state power switch

A solid state amplifier has an output transistor stage and an input transistor stage interconnected as a Darlington circuit. An interstage transistor interconnecting the collectors of the two stages of the Darlington circuit is connected with the first stage transistor in a compound configuration. When the load current furnished by the amplifier is less than a predetermined value, the output stage operates as a simple saturated switch with its base drive current flowing through the emitter-base junction of the first stage which produces no collector current because the base-emitter junction of the interstage transistor is reverse-biased. When the load current exceeds said predetermined value, the interstage transistor begins to conduct allowing the input and output stages to operate as a Darlington amplifier and diverting a significant portion of the base drive current of the output transistor back into the load.

Maus, Louis C.

Digital Fringe Counting for Intrinsic Fabry-Perot Interferometers

A digital dual-wavelength method of demodulating long (17cm) Intrinsic Fabry-Perot Interferometers (IFPI) is presented. The method builds upon previous techniques using small shifts in the lasing wavelength of a laser diode induced by changes in the driving current. The intensity of the light reflected from the IFPI is sampled at two carefully selected values of laser diode drive current. Digital logic is then used to count fringes based upon these two sampled values. Experimental verification of the method is described.

Froggatt, Mark

Power-Conserving Stepping-Motor Drive Circuits

Two improved drive circuits for sinusoidally commutated stepping motor include feedback loops reducing unnecessary consumption of power by reducing drive-current amplitude, I, when motor operates under light load. Basic design strategy attempts to supply only little more current than minimum needed to overcome friction in lightly loaded condition. In this sinusoidally commutated two-phase stepping motor, magnetic field generated by drive currents in phase-A and phase-B stator windings urges rotor toward commanded angle x.

Nola, Frank J.

Constant-voltage drive current-steering switch

Two-element voltage control system regulates a magnetic switch consisting of dual ferrite-core shift registers. The system has a magnetic, two-core-per-bit, voltage-controlled shift register.

Caplette, R. K.

Driven, steady-state RFP computations

The pseudospectral three-dimensional MHD code of Dahlburg et al. (1986 and 1987) is used to compute the dynamical behavior of a channel of magnetofluid carrying an axial current and magnetic flux. This situation contains the essential MHD behavior of the reversed-field pinch (RFP). An externally imposed electric field is applied to an initially current-free magnetofluid and drives currents that rise and eventually fluctuate about values corresponding to pinch ratios Theta of about 1.3, 2.2, and 4.5. A period of violent turbulence leads to an approximately force-free core, surrounded by an active MHD boundary layer that is not force-free. A steady state is reached that can apparently be sustained indefinitely (for several hundred Alfven transit times or longer). The turbulence level and time variability in the steady state increase with increasing Theta. The average toroidal magnetic field at the wall reverses for Theta = 2.2 and 4.5, but not for Theta = 1.3. Negative toroidal current filaments are observed. The Lundquist numbers are of the order of a few hundred.

Dahlburg, J. P.