Engineering topics
Publications and source records attributed to Chen, T. T..
Simple loop first-in-first-out (FIFO) bubble memory shift register has continuous storage capability. Bubble shift register simplifies chip-control electronics by enabling all control functions to be alined at same bit. FIFO shift register is constructed from passive replicator and annihilator combinations.
Experiments were devised to study the angular variation of the resistance and noise properties of one- and two-level chevron stretcher magnetoresistive detectors for use in field access bubble memory devices. All measurements, made with an electronic system, were performed on glass or garnet samples upon which 1 micron of SiO2 was sputter-deposited, followed by 4000 A of Permalloy for the 28-micron-period devices and 0.8 microns of SiO2, followed by 3000 A of Permalloy for the 20-micron-period devices. The geometrical and drive-state dependence of the zero-state noise were studied, as was its frequency dependence. It is found that both types of detectors operate primarily in the amplitude-shift mode for drive fields of interest and that the presence of a bubble in a detector causes a magnetoresistance change equal to that produced by increasing the in-plane drive field about 8 Oe in the absence of a bubble.
Concept has several important advantages over close-wound system: memory and coil chips are separate and interchangeable; interconnections in coil level are eliminated by packing memory chip and electronics in single structure; and coil size can be adjusted to optimum value in terms of power dissipation and field uniformity.
Size and thickness of field adjusting plate can be varied. Memory chip specification is relaxed, since chips in structure need not be matched in bias margin.
Design includes multi-channel replicator which can reduce chip-writing requirement, selective annihilating switch which can effectively annihilate bubbles with minimum delay, and modified transfer switch which can be used as selective steering-type decoder.
Coil etched from conductive film has better field uniformity than wire-wound coils and less coil loss at high-frequency operation.
Stripe-line pattern is etched on both sides of double-sided film. Since conductor thickness is only half that of single-sided film, problems in wrapping and etching are greatly reduced.
Coil structures have been designed to permit nondestructive testing of bubble wafers. Wafers can be electrically or optically inspected and operated from quasi-static frequency to maximum device operating frequency.
System integration methods for bubble domain flight records are investigated. Bubble memory module packaging and assembly, the control electronics design and construction, field coils, and permanent magnet bias structure design are studied. A small 60-k bit engineering model was built and tested to demonstrate the feasibility of the bubble recorder. Based on the various studies performed, a projection is made on a 50,000,000-bit prototype recorder. It is estimated that the recorder will occupy 190 cubic in., weigh 12 lb, and consume 12 w power when all of its four tracks are operated in parallel at 150 kHz data rate.
A feasibility model of an all-electronic bubble memory system has been constructed. It uses a small 60k bit bubble recorder consisting of 6 chips of 10k bits each mounted in three separate packages operating as a FIFO at a 150 KHz bubble data rate. In addition to serving as a direct tape recorder replacement, the bubble recorder can be programmed for random access to each individual chip for ranom block access operation or for self-checking or by-passing any malfunctioning memory chip. Read and write operations can be performed asynchronously from very low frequency up to basic recording field frequency. A large 50M bit prototype is planned.