Search NASA⌕ Search

Engineering topics

Mcgillem, C. D.

Publications and source records attributed to Mcgillem, C. D..

34 records · Page 2
All sourcesNASA NTRSDOE OSTI
NASA NTRS1976

Analytical and experimental design and analysis of an optimal processor for image registration

The author has identified the following significant results. A quantitative measure of the registration processor accuracy in terms of the variance of the registration error was derived. With the appropriate assumptions, the variance was shown to be inversely proportional to the square of the effective bandwidth times the signal to noise ratio. The final expressions were presented to emphasize both the form and simplicity of their representation. In the situation where relative spatial distortions exist between images to be registered, expressions were derived for estimating the loss in output signal to noise ratio due to these spatial distortions. These results are in terms of a reduction factor.

Mcgillem, C. D.↗
NASA NTRS1976

Experimental examination of similarity measures and preprocessing methods used for image registration

The criterion used to measure the similarity between images and thus find the position where the images are registered is examined. The three similarity measures considered are the correlation coefficient, the sum of the absolute differences, and the correlation function. Three basic types of preprocessing are then discussed: taking the magnitude of the gradient of the images, thresholding the images at their medians, and thresholding the magnitude of the gradient of the images at an arbitrary level to be determined experimentally. These multitemporal registration techniques are applied to remote imagery of agricultural areas.

Svedlow, M.↗
NASA NTRS1975

Interpolation of ERTS-1 multispectral scanner data

Three interpolation procedures, based on computing values between original sample points, for enlarging a picture are examined. An ERTS frame of Washington, D.C. was used to illustrate the results. Mathematical bases of the interpolation are given.

Mcgillem, C. D.↗
NASA NTRS1975

Resolution enhancement of ERTS imagery

A method is described for combined interpolation and enhancement of ERTS multispectral scanner data sets. Previous research has shown that good enhancement is most easily achieved when there are a large number of data points contained within the radius of gyration of the system point spread function. This requirement can be met using ERTS data by interpolating the data before enhancement. By varying the interpolation scale factor the data set can be empirically matched to a precalculated optimum restoration filter. Once the proper match of data and filter has been found the enhancement can be carried out directly or the enhancement and interpolation operations can be combined into a single filter thereby greatly reducing the processing time. Experimental results of applying this technique are shown along with more conventional methods of image interpolation and enlargement.

Mcgillem, C. D.↗
NASA NTRS1975

Ghost suppression in image restoration filtering

An optimum image restoration filter is described in which provision is made to constrain the spatial extent of the restoration function, the noise level of the filter output and the rate of falloff of the composite system point-spread away from the origin. Experimental results show that sidelobes on the composite system point-spread function produce ghosts in the restored image near discontinuities in intensity level. By redetermining the filter using a penalty function that is zero over the main lobe of the composite point-spread function of the optimum filter and nonzero where the point-spread function departs from a smoothly decaying function in the sidelobe region, a great reduction in sidelobe level is obtained. Almost no loss in resolving power of the composite system results from this procedure. By iteratively carrying out the same procedure even further reductions in sidelobe level are obtained. Examples of original and iterated restoration functions are shown along with their effects on a test image.

Riemer, T. E.↗
NASA NTRS1974

Moire patterns and two-dimensional aliasing in line scanner data acquisition systems

The basic mechanism underlying the generation of Moire patterns in line scanner data acquisition systems is examined. A general expression is developed in terms of typical system parameters for the reproduced image of such systems and the interaction of the image spectrum; the raster frequency and digital sampling frequency of the A/D conversion process are discussed and examples given. System design requirements for avoiding Moire pattern generation and two-dimensional aliasing are discussed.

Mcgillem, C. D.↗
NASA NTRS1974

Optimum constrained image restoration filters

The filter was developed in Hilbert space by minimizing the radius of gyration of the overall or composite system point-spread function subject to constraints on the radius of gyration of the restoration filter point-spread function, the total noise power in the restored image, and the shape of the composite system frequency spectrum. An iterative technique is introduced which alters the shape of the optimum composite system point-spread function, producing a suboptimal restoration filter which suppresses undesirable secondary oscillations. Finally this technique is applied to multispectral scanner data obtained from the Earth Resources Technology Satellite to provide resolution enhancement. An experimental approach to the problems involving estimation of the effective scanner aperture and matching the ERTS data to available restoration functions is presented.

Riemer, T. E.↗
NASA NTRS1973

Constrained optimization of image restoration filters.

A preprocessing method to correct for image degradation is proposed which can be thought of as a generalization and extension of previous work by Smith (1966) and Stuller (1972). This method accomodates the problem of noncircularly symmetric imaging system point-spread functions, provides for controlled extent of the preprocessing filter to minimize distortion due to transients resulting from truncation errors and edge effects, can be used with various kinds of system noise, and can be readily extended to provide constraint of other system parameters. The analysis relates to a line-scanner system, although it is applicable in principle to many other system configurations.

Riemer, T. E.↗
NASA NTRS1973

Moire patterns and two-dimensional aliasing in line scanner data acquisition systems

The basic mechanism underlying the generation of Moire patterns in line scanner data acquisition systems is examined. A general expression is developed in terms of typical system parameters for the reproduced image of such systems and the interaction of the image spectrum; the raster frequency and digital sampling frequency of the A/D conversion process are discussed and examples given. Systems design requirements for avoiding Moire pattern generation and two-dimensional aliasing are discussed.

Mcgillem, C. D.↗
NASA NTRS1973

Constrained optimization of image restoration filters

A linear shift-invariant preprocessing technique is described which requires no specific knowledge of the image parameters and which is sufficiently general to allow the effective radius of the composite imaging system to be minimized while constraining other system parameters to remain within specified limits.

Riemer, T. E.↗
NASA NTRS1973

A linear shift-invariant image preprocessing technique for multispectral scanner systems

A linear shift-invariant image preprocessing technique is examined which requires no specific knowledge of any parameter of the original image and which is sufficiently general to allow the effective radius of the composite imaging system to be arbitrarily shaped and reduced, subject primarily to the noise power constraint. In addition, the size of the point-spread function of the preprocessing filter can be arbitrarily controlled, thus minimizing truncation errors.

Mcgillem, C. D.↗
NASA NTRS1972

Conjugate point determination for multitemporal data overlay

The machine processing is discussed of spatially variant multitemporal data such as imagery obtained at different times which requires that these data be in geometrical registration so that the analysis processor may obtain the datum for a specified ground resolution element in each of the sets of imagery being utilized for analysis. Misregistration between corresponding subsets of imagery contains both a displacement and a geometrical distortion component. Search techniques utilizing the moduli of the Fourier Transforms are developed for estimating the coefficients of geometrical distortion components of this model. Following the correction of these distortion components, the displacement is located by the crosscorrelation of a template obtained from one set of data, termed the reference, with the second, or background data. This template, derived for the optimum discrimination of the reference data embedded in the background, is determined by the solution of a system of equations involving the reference data and the covariance matrix of these data.

Emmert, R. A.↗
NASA NTRS1966

A broadband interferometer.

Power response of two-element interference frequency correlation interferometer to point source of broadband random noise

RANDOM SIGNAL↗
NASA NTRS1965

A wideband digital correlator.

Envelope polarity coincidence crosscorrelator for detection and identification problems involving weak wideband microwave signals

MICROWAVE TRANSMISSION↗