SEARCH · Search NASA

Results for “microwave/millimeter-wave”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

SourceResearch connectionFrom yearThrough year

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

10 records

All sources NASA NTRS DOE OSTI

NASA NTRS1986

Analysis of optically controlled microwave/millimeter-wave device structures

The light-induced voltage and the change in the source-to-drain channel current under optical illumination higher than the semiconductor bandgap for GaAs MESFET, InP MESFET, Al0.3Ga0.7As/GaAs high electron mobility transistor (HEMT) and GaAs permeable base transistor (PBT) were analytically obtained. The GaAs PBT and GaAs MESFET have much higher sensitivity than InP MESFET. The Al0.3Ga0.7As/GaAs HEMT is observed to have the highest sensitivity. Variation in device parasitics due to optical illumination and its effect on the cutoff frequencies f sub T and f sub max are also investigated.

Simons, Rainee N.↗

NASA NTRS1989

System feasibility study of a microwave/millimeter-wave radar for space debris tracking

A 35 GHz millimeter-wave radar system has been studied for space debris tracking. The objective is to track the particles ranging in size from 4 mm to 80 mm up to a range of 25 km. The system requires various state-of-the-art technologies including phased arrays, monopulse tracking, pulse compression, high power transmitters, low noise receivers, and pulse integration signal processing techniques.

Chang, Kai↗

NASA NTRS1989

Fiber optic links for microwave/millimeter-wave systems

Recent advances in device technology for microwave/mm-wave (M/MMW) analog fiber-optic communication systems are surveyed, with discussion of system parameters, design optimization methods, and hardware selection and manufacturing considerations. Particular attention is given to 1-km-link systems operating at 21, 30, and 12 GHz for satellite-communication, electronic-warfare, and radar applications. The design and fabrication simplicity of direct modulation is weighed against the wide bandwidth, low distortion, and mm-wave and frequency operation advantages of external modulation. Homodyne or heterodyne coherent detection is shown to improve system S/N by 10-20 dB over conventional detection methods. Diagrams, drawings, photographs, and graphs of typical performance data are included.

Pan, J. J.↗

DOE OSTI2020

Efficient Image Reconstruction Method for a Millimeter-wave Shoe Scanner

The Pacific Northwest National Laboratory (PNNL) has recently developed an active 3D microwave/millimeter-wave shoe scanner. This system is designed to detect threats concealed within the soles of common footwear. The system operates over the 10-40 GHz frequency range for excellent penetration of common materials. The system presents several challenges for efficient image reconstruction, including the thick dielectric window, multi-row linear arrays, and focusing close to the antenna elements. In this paper, an efficient back-projection reconstruction algorithm is presented that overcomes these challenges. Experimental imaging results are shown that demonstrate high-resolution imaging performance for this new scanner.

Sheen, David M.↗

NASA NTRS1980

Performance analysis and simulation of the SPS reference phase control system

The solar power satellite (SPS) concept envisions several hundred thousand synchronized microwave power amplifiers operating in parallel to produce an aggregate power output of 5-10 GW. This power is to be transferred to earth with the aid of a microwave/millimeter-wave beaming system operating in a synchronous orbit. The reference phase control system is considered along with aspects of pilot signal parameter selection. A power transponder analysis is conducted and an SPS performance evaluation is performed. Attention is given to system jitters and imperfections, the definition of power transfer efficiency, and the effects of system imperfections on SPS efficiency. It is found that the power transfer efficiency is relatively insensitive to the amplitude jitters. However, the effects of location jitters can produce a severe degradation of efficiency.

Chie, C. M.↗

NASA NTRS1986

Monolithic 20-GHz Transmitting Module

20-GHz monolithic microwave/millimeter-wave integrated circuit (MMIC) with amplification and phase-shift (time-delay) capabilities developed. Use of MMIC module technology promises to make feasible development of weight- and cost-effective phased-array antenna systems, identified as major factor in achieving minimum cost and efficient use of frequency and orbital resources of future generations of communication satellite systems. Use of MMIC transmitting modules provides for relatively simple method for phase-shift control of many separate radio-frequency (RF) signals required for phased-array antenna systems.

Kascak, T.↗

NASA NTRS1991

35 GHz integrated circuit rectifying antenna with 33 percent efficiency

A 35 GHz integrated circuit rectifying antenna (rectenna) has been developed using a microstrip dipole antenna and beam-lead mixer diode. Greater than 33 percent conversion efficiency has been achieved. The circuit should have applications in microwave/millimeter-wave power transmission and detection.

Yoo, T.-W.↗

NASA NTRS2001

Coupling Between Microstrip Lines Embedded in Polyimide Layers for 3D-MMICs on Si

Three-dimensional circuits built upon multiple layers of polyimide are required for constructing Si/SiGe monolithic microwave/millimeter-wave integrated circuits on CMOS (low resistivity) Si wafers. However, the closely spaced transmission lines are susceptible to high levels of coupling, which degrades circuit performance. In this paper, Finite Difference Time Domain (FDTD) analysis and measured characteristics of novel shielding structures that significantly reduce coupling between embedded microstrip lines are presented.

Ponchak, George E.↗

NASA NTRS2001

Coupling Between Microstrip Lines with Finite Width Ground Plane Embedded in Polyimide Layers for 3D-MMICs on Si

Three-dimensional circuits built upon multiple layers of polyimide are required for constructing Si/SiGe monolithic microwave/millimeter-wave integrated circuits on complementary metal oxide semiconductor (CMOS) (low resistivity) Si wafers. Thin film microstrip lines (TFMS) with finite width ground planes embedded in the polyimide are often used. However, the closely spaced TFMS lines are susceptible to high levels of coupling, which degrades circuit performance. In this paper, Finite Difference Time Domain (FDTD) analysis and experimental measurements are used to show that the ground planes must be connected by via holes to reduce coupling in both the forward and backward directions.

Ponchak, George E.↗

NASA NTRS1994

Transmission Lines for High Frequency and High Density Packaging

We report on resistivity and chemical stability of Cr/Au bilayers deposited by sputtering on three kinds of substrates: alumina, aluminum nitride and aluminum nitride coated alumina. The insertion loss of Cr/Au microstrip lines fabricated on these three substrates was low and stable after 100 cycles in the -65 degree C to 125 degree C temperature range.

high-frequency↗